locogato11283

Yea, MFers.

I don't believe anything you say. You always say we're going to party, then never follow through. Sad face.

Aren't they almost a Shearer clone?

Never done a plug chop. Looks like a pain.

Coming up quick!!

Move out of CA. Problem solved.

I wouldn't waste money on the Flex bars. That's a ridiculous expense. I have this Alba +2 stem. It's nice. https://www.ebay.com/itm/184955487409?fits=Make%3AYamaha&itmmeta=01HVVK777EVB43A4DXQXZDJVYD&hash=item2b1034c4b1:g:jdcAAOSwcaFZH0ca&itmprp=enc%3AAQAJAAAA0Bd9Cskx2%2Fa2%2FfQcfzQMhMWXIUGeBAwqgTER862IQb%2F0AWp9kmfdnCFKiGwTBAIbvHWh92FxjQK8QNjFYOwoiTnPNmldxPXRBWAJZdRS5b4oNNgR68DYEpyLV%2FGkc9SfaDdYvvkjBtL41rt4QXRp7EHgUmG%2BH9Zx3AUsZHG6ylZOp4tXSbBjiUNRUfVRtQjUe3N77QtA9EGlMTHHyXcGPuSbe4zQ1qtn5ab%2B5ffF40KoYhAekZ6mg%2Fc%2B6ANHX1zcszF9CkLgBGbnpgLHZ4GDX1M%3D|tkp%3ABk9SR-jznPPeYw A-arms typically come with the correct tie rods. What "clutch setup?" I'd buy a new cable. Again, a fraction of the cost of Magura. Go with Driveline sprockets and chain.

You can just ditch the tank completely. As long as the radiator is staying full, you're good. Just run the hose that goes to the tank straight to the ground.

That’s bullshit. They are not “good out of the box.” First trip on mine out of the box and the fucking float fell out of one carb and then I pulled one of the fuel inlets out. Total junk. PWK is a superior carb.

Lectrons are junk. I'd go with Keihin PWK.

No.

Have you checked your coolant? If the gasket or o-rings are bad, it can pull coolant at high RPMs. This could’ve happened overnight as well.

You can’t. Rivets have to be ground and driven out.

Just tighten them a lot and be done with it. I’ve never torqued them.