Banshee Repairs and Mods

38,655 topics in this forum

1. Oil coming out of exhaust.

   By Bammer350cc, May 30, 2013
   • 2 replies
   • 520 views
   • 
   • hoppedupandcutdown
   • May 31, 2013

2. compression

   By Bennett69, May 31, 2013
   • 4 replies
   • 406 views
   • 
   • Bennett69
   • May 31, 2013

3. Rear Axle Jam Nut Loose 1 2

   By bansheeDre, May 23, 2013
   • 19 replies
   • 3k views
   • 
   • Dick Dragon
   • May 31, 2013

4. double gasser

   By bansheedemon, May 30, 2013
   • 3 replies
   • 457 views
   • 
   • Starwriter
   • May 30, 2013

5. this is a crazy idea but... 1 2

   By bansheegoon, April 30, 2013
   • 21 replies
   • 1.7k views
   • 
   • BANSHEE CHAOS
   • May 30, 2013

6. lug nut size

   By draggins10, May 29, 2013
   • 5 replies
   • 5.9k views
   • 
   • draggins10
   • May 30, 2013

7. timing problem

   By ben-driscoll, May 28, 2013
   • 6 replies
   • 744 views
   • 
   • trickedcarbine
   • May 30, 2013

8. An Excessive amount of White Smoke 1 2

   By EvilCerberus, May 11, 2013
   • 23 replies
   • 1.7k views
   • 
   • oldskool
   • May 29, 2013

9. Clutch noise

   By midlifecrisis, May 29, 2013
   • 2 replies
   • 687 views
   • 
   • amado814
   • May 29, 2013

10. Port Layout

    By kshoulde35, May 29, 2013
    • 5 replies
    • 572 views
    • 
    • Coupelx
    • May 29, 2013

11. Coolant coming from little hose 1 2

    By Mad_banshee_racer, May 21, 2013
    • 20 replies
    • 2.2k views
    • 
    • toytech
    • May 29, 2013

12. vf3 reeds cascade stuffers

    By jdsfel, May 29, 2013
    • 1 reply
    • 489 views
    • 
    • Oregon dunner
    • May 29, 2013

13. shift selector shaft(stuck in 2nd and 3rd only)

    By bansheegoon, May 28, 2013
    • 3 replies
    • 537 views
    • 
    • hoppedupandcutdown
    • May 29, 2013

14. Loss of Power

    By AlkyHogBanshee, May 28, 2013
    • 14 replies
    • 832 views
    • 
    • trickedcarbine
    • May 28, 2013

15. what carbs to get

    By bansheedemon, May 28, 2013
    • 6 replies
    • 553 views
    • 
    • bansheedemon
    • May 28, 2013

16. Chain breaking issue 1 2

    By atcandbanshees, April 22, 2013
    • 15 replies
    • 1.6k views
    • 
    • atcandbanshees
    • May 28, 2013

17. Base gasket? Thinnest.

    By facetiousxm, May 11, 2013
    • 13 replies
    • 1.2k views
    • 
    • facetiousxm
    • May 28, 2013

18. Cub Water Jacket Plug?

    By fastbshee, May 25, 2013
    • 3 replies
    • 1.9k views
    • 
    • Finch
    • May 28, 2013

19. how do figure rough hp numbers? no dyno available around

    By 385banshee, May 28, 2013
    • 9 replies
    • 564 views
    • 
    • trickedcarbine
    • May 28, 2013

20. time for rebuild?

    By alpine04, May 26, 2013   

    • compression
    • crank
    • (and 4 more)

      Tagged with:

      • compression
      • crank
      • seal
      • crank seal
      • shitty
      • no power
    • 6 replies
    • 931 views
    • 
    • paulieepaul
    • May 28, 2013

21. electrical problem?

    By paulieepaul, May 28, 2013   

    • stator
    • cdi
    • 0 replies
    • 794 views
    • 
    • paulieepaul
    • May 28, 2013

22. Is this idle to low?

    By Uf21, May 20, 2013
    • 12 replies
    • 1.8k views
    • 
    • Jereme6655
    • May 27, 2013

23. What tranny to use? 1 2 3

    By gordo_dk, May 25, 2013
    • 39 replies
    • 2.2k views
    • 
    • camatv
    • May 26, 2013

24. 35 pwk to 39 pwk

    By Oregon dunner, May 26, 2013
    • 3 replies
    • 508 views
    • 
    • 5150banshee
    • May 26, 2013

25. Anyone know what might cause this?

    By SEBanshee, May 25, 2013
    • 1 reply
    • 526 views
    • 
    • trickedcarbine
    • May 26, 2013

26. piston angle

    By oldskool, May 26, 2013
    • 3 replies
    • 755 views
    • 
    • Coupelx
    • May 26, 2013

27. The top of my exhaust port is 27.5 mm from the top of the jug, what level porting is it?

    By rg97, May 26, 2013
    • 6 replies
    • 658 views
    • 
    • trickedcarbine
    • May 26, 2013

28. piston question 1 2

    By bansheedemon, May 22, 2013
    • 17 replies
    • 1.3k views
    • 
    • bansheedemon
    • May 26, 2013

29. smoke out right pipe after shutting banshee down

    By bansheedemon, May 24, 2013
    • 10 replies
    • 530 views
    • 
    • bansheedemon
    • May 25, 2013

30. Trying to figure out the wire size on the harness

    By t bone, May 25, 2013
    • 3 replies
    • 1.1k views
    • 
    • t bone
    • May 25, 2013

31. Compression check help.. 1 2

    By The-Association, May 23, 2013
    • 16 replies
    • 1.1k views
    • 
    • The-Association
    • May 25, 2013

32. Compression question

    By Yanbansh04, May 23, 2013
    • 10 replies
    • 774 views
    • 
    • Yanbansh04
    • May 25, 2013

33. A little bit of a different spark coil question. But a simple one.

    By KarTek, May 15, 2013
    • 8 replies
    • 881 views
    • 
    • KarTek
    • May 24, 2013

34. Front Caliper Bushing

    By Azryll, May 23, 2013
    • 2 replies
    • 436 views
    • 
    • Nightmare
    • May 24, 2013

35. What brand axle is this? 1 2 3

    By 87sheerips, May 5, 2013
    • 31 replies
    • 2.3k views
    • 
    • 87sheerips
    • May 24, 2013

36. Spark cut out.

    By RACxEMxWILLIE, May 24, 2013
    • 2 replies
    • 476 views
    • 
    • Jereme6655
    • May 24, 2013

37. frame

    By blakeriley, May 23, 2013   

    • banshee frame
    • 9 replies
    • 751 views
    • 
    • Nightmare
    • May 24, 2013

38. billet 10 mil crank

    By frog, May 24, 2013
    • 1 reply
    • 638 views
    • 
    • Wildcardracing
    • May 24, 2013

39. Trans keeps popping out of first

    By virustech, May 23, 2013
    • 8 replies
    • 1.3k views
    • 
    • virustech
    • May 24, 2013

40. banshee workin like crap 1 2

    By alpine04, May 20, 2013   

    • toomey
    • t5
    • (and 8 more)

      Tagged with:

      • toomey
      • t5
      • toomey t5
      • banshee
      • cylinder
      • UNI
      • exhaust
      • jet
      • jetting
      • trouble
    • 20 replies
    • 2k views
    • 
    • alpine04
    • May 24, 2013