Jetting & Exhaust Forum

11,170 topics in this forum

1. T5 Fitting Problem

   By Klotz, February 23, 2004
   • 1 reply
   • 437 views
   • 
   • DUNEDEMON
   • February 23, 2004

2. Paul Turner Fat Boy 2

   By 80yota, March 20, 2014
   • 1 reply
   • 455 views
   • 
   • 80yota
   • March 20, 2014

3. YFZ450 Jetting Question

   By watkins, August 29, 2005
   • 1 reply
   • 466 views
   • 
   • Ducman
   • September 6, 2005

4. Sparkplug

   By biohaz, August 5, 2009
   • 1 reply
   • 432 views
   • 
   • TwistedSheeRida
   • August 5, 2009

5. oil ratio

   By bombedbanshee06, February 14, 2006
   • 1 reply
   • 350 views
   • 
   • watkins
   • February 14, 2006

6. Spark Arrestors

   By MrTJ, February 23, 2004
   • 1 reply
   • 432 views
   • 
   • die_infidel
   • February 24, 2004

7. HELP Removing Domes

   By JustinBCrazy, May 4, 2009
   • 1 reply
   • 541 views
   • 
   • AKheathen
   • May 6, 2009

8. Timing Plate Jetting...

   By FOXBANSHEE30, September 26, 2005
   • 1 reply
   • 533 views
   • 
   • hittintrees srh
   • September 26, 2005

9. Question about exhaust headpipe springs.

   By ATVridinMaNiAc, August 4, 2012
   • 1 reply
   • 393 views
   • 
   • sheerider11
   • August 4, 2012

10. Cylinder size to piston size

    By Noob Banshee, August 4, 2004
    • 1 reply
    • 290 views
    • 
    • Noob Banshee
    • August 4, 2004

11. ctane vs. comprssion

    By cbn70, August 29, 2006
    • 1 reply
    • 342 views
    • 
    • dajogejr
    • August 29, 2006

12. Gas In Carbs

    By 2004LEBanshee, December 3, 2003
    • 1 reply
    • 600 views
    • 
    • txblueshee
    • December 3, 2003

13. Cpi And Aircleaners

    By Ultimateduner, January 23, 2004
    • 1 reply
    • 445 views
    • 
    • Just for fun
    • January 23, 2004

14. Another where to start my jetting at thread..

    By someone82, March 31, 2008
    • 1 reply
    • 431 views
    • 
    • someone82
    • March 31, 2008

15. adjusting jetting for temp differences

    By official_style, February 10, 2010
    • 1 reply
    • 442 views
    • 
    • GrMeyer
    • February 10, 2010

16. 20cc dome jet sizing

    By Tarrenitup82, January 10, 2023
    • 1 reply
    • 798 views
    • 
    • Tarrenitup82
    • January 10, 2023

17. Carb sync

    By Dragking99, April 13, 2023
    • 1 reply
    • 501 views
    • 
    • Tedder
    • April 14, 2023

18. where to start?

    By chevy7398, November 22, 2006
    • 1 reply
    • 341 views
    • 
    • BansheeDan
    • November 22, 2006

19. Jetting advice needed

    By shoopie, October 3, 2010
    • 1 reply
    • 530 views
    • 
    • GrMeyer
    • October 3, 2010

20. New Toomey air Intake

    By aussiemxer, March 15, 2007
    • 1 reply
    • 888 views
    • 
    • 2003LimitedBanshee
    • March 15, 2007

21. quick question

    By oreoshee350, July 5, 2007
    • 1 reply
    • 458 views
    • 
    • Toomey Banshee
    • July 9, 2007

22. Reading Plugs

    By illboogie, November 29, 2003
    • 1 reply
    • 558 views
    • 
    • Banchetta
    • November 29, 2003

23. Needle notch?

    By Newcs222, April 20, 2014
    • 1 reply
    • 478 views
    • 
    • special06shee
    • April 20, 2014

24. Stock jetting & elevation

    By c. wilson, July 5, 2007
    • 1 reply
    • 2.2k views
    • 
    • dajogejr
    • July 5, 2007

25. Jetting toomey T5's

    By marcP, May 26, 2008
    • 1 reply
    • 636 views
    • 
    • lilmikey
    • May 31, 2008

26. Trinity IV VS FMF Fatties

    By Loc, April 30, 2009
    • 1 reply
    • 630 views
    • 
    • shanYE west
    • April 30, 2009

27. What jets should I run.

    By Fastassbanshee96, April 11, 2010
    • 1 reply
    • 562 views
    • 
    • rascal
    • April 13, 2010

28. Small Bore vs. Big Bore Pipes

    By jayzx10r, March 28, 2007
    • 1 reply
    • 939 views
    • 
    • FireHead
    • March 28, 2007

29. Jetting TM-34mm Mikuni Flat Slides

    By greg_banshee, June 30, 2011
    • 1 reply
    • 1k views
    • 
    • camatv
    • July 1, 2011

30. Question regarding Factory silencers...

    By SHAFT, September 26, 2004
    • 1 reply
    • 431 views
    • 
    • sredish
    • September 26, 2004

31. Thank you... but! Addtional questions

    By Minister of Death, May 28, 2009
    • 1 reply
    • 441 views
    • 
    • BoostedRex
    • May 28, 2009

32. Slide Installation Question

    By watkins, October 15, 2005
    • 1 reply
    • 377 views
    • 
    • watkins
    • October 15, 2005

33. Help

    By Help with jetting, April 30, 2024
    • 1 reply
    • 367 views
    • 
    • locogato11283
    • April 30, 2024

34. Out of fram drag pipes

    By kman2785, October 22, 2003
    • 1 reply
    • 882 views
    • 
    • Banchetta
    • October 22, 2003

35. Jetting For My Shee

    By spdfreak98, November 24, 2003
    • 1 reply
    • 596 views
    • 
    • Banchetta
    • November 25, 2003

36. Toomey Spark Arrestors

    By bluesheeboy, February 6, 2004
    • 1 reply
    • 611 views
    • 
    • spoin39
    • February 7, 2004

37. where should i start?

    By revedup04, March 26, 2008
    • 1 reply
    • 467 views
    • 
    • revedup04
    • April 3, 2008

38. Help me with a base setting

    By GSXKID, May 14, 2008
    • 1 reply
    • 346 views
    • 
    • dajogejr
    • May 14, 2008

39. 35 pwk jetting kind of weird.

    By facetiousxm, June 15, 2013
    • 1 reply
    • 423 views
    • 
    • facetiousxm
    • June 15, 2013

40. plugs are telling me nothing.

    By TJScott, March 26, 2009
    • 1 reply
    • 365 views
    • 
    • AKheathen
    • March 26, 2009