Sniper pipe fitment

[Andreb84]

Theres a pretty big gap where the pipe pushes into the cylinder....my cpis where a much more snug fit is this normal?

[Andreb84]

 

 

Sent from my iPhone using Tapatalk

[sheerider11]

No that's not normal. Put some grease in there and see if it goes on better

[Craig B]

Mine fit better than that. Grease them bitches up and slide em on!

[trickedcarbine]

You're just against the o ring. Lube it and use some elbow grease.

[Andreb84]

Lol i lubed it i guess i didnt use enough....i was layin on my back underneath the bike damn near trying to bench press it on...will try again tomorrow

[sleeper06]

Wow , yeh that's no good, take all bolts out , grease it up, wiggle, spin, push thy bitch on , then springs, then bolts

[RagunCajun]

Be careful the oring isn't caught. I just ripped 3 of them.

[special06shee]

If ya cant get them, remove o-rings and sand them down a bit.

[guns4children]

FFS this is the best fitting pipe on the market?? I know they are light years better than shears but damn.

[Andreb84]

This shit is really starting to piss me off..i knicked up my frame trying to put this fucking pipe on i had to stop my self from ripping it off the bike and throwing that shit 100 yards down the street....someone mentioned sanding down my cylinder i dont think i should have to do that to install a pipe

[elconor]

You just need the proper sized orings. And he meant to sand down the oring to gain clearance

Edited April 12, 2016 by elconor

[rjdgriff]

Man up and shove it on FFS

 

Trail Bikes, FTW

[locogato11283]

Would you rather have pipes that blow shit out of them all the time?

[Bennett131]

Hit it with your purse!