vbanshee

ok fellas so i have a rebuilt motor out of the base of the cylinder on the left side it is leaking oil. theres a new gasket in there and al the bolts are torqued down to the correct specs. what is my problem? bad gasket? thanks guys!

good luck with the sale good save over retail... but good to put where your located.... and shipping info!

thanks fellas. lol way to boost my self esteem!

i just hooked up my new front end on my shee. got new brake lines i connected them but no brake fluid is getting through the lines the brakes wont get hard. do i bleed them?

possibly clutch

thats a good way to break it in. but usually i do 3 heat cycles. MAKE SURE YOU RE TORQUE the bolts! then do three 15 minute riding sessions one at 1/4 throttle. second at 1/2 throttle then full throttle all in between riding sessions let the bike cool completley

ya never reuse gaskets. and loctite your shit !!!!

ok fellas ... i had this problem and got it fixed first thing its a stupid mistake but a lot of people do this did you locktite and do three torque sequences to head. make sure if not theres no compression holding in the coolant. if you did that then you have a blown head gasket/ o rings. but most likely its the first thing i said i had chris on here help me out after i re torqued it all it was fine

x2 hes right

x2 throw it up on a jack or if you dont have a jack a spare tire or something take of the rear tires and just have the bike in first and put sand paper to tge axle. if you have a buddy who can give it gas in third gear it will be faster

they go off of what the "book" says.they whill charge you 2 hours of labor to take out the motor when it really takes 20 minutes

happened to me last week i rebuilt my motor but never re torqued the bolts to the head . if you did that than. bad o ring or gasket or bad impeller

got some works shocks and in no longer need of the stock shocks. in good condition NOT blown or anything like that. mostly dune riding on them. 50 dollars firm. BUY IT AND ILL PAY THE SHIPPING thanks fellas

that radiator for sale?

pics oflack nerfs. [email protected]

i run 19's never had a problem with them but have to run race gas (according to pro design)

well on obvious problem is that your from new zealand haha jk anywho check around the head see if theres coolant leaking out of it

flywheel sold

x3 8 paddle haulers awesome

my buddy runs them on his. they look good and a lot brighter. no problems yet

so whats my best option? take off the cool head and see if if any of the o rings are blown? i was pinned for about 30 seconds or so. but still hauling balls for about 10 minutes

so im racing my buddy pinned 6th and all of a suddent coolant comes shooting out of the hose from the ressivor. there is a hose that goes into the ressi but now once i start my bike all the coolant goes in to the resivor??????? what is wrong ahhhhh

pics to [email protected] the axle thanks

definatly works

email sent!