Jump to content

Larry's Shee

Members
  • Posts

    4,928
  • Joined

  • Last visited

  • Days Won

    6

Everything posted by Larry's Shee

  1. JDS/ 87sheeeipa has the screens
  2. First thing I would try is reducing pre-load, that's free
  3. Reeds sitting tight to cage? No chips, cracks, frays?
  4. That is NOT the way to do it. Might pay to look in the manual for torque values, it's not much, like 7 lbs , tightened diagonally in stages. Might have warped the boot or cage.
  5. Ummmm, maybe should have given him a clue.It is possible to leak between case halves
  6. So now did leakdown go ? Very few if any shift into neutral while running.
  7. Don't worry, had to ask my son what "smh" was
  8. Float probably stuck. Happens sometimes after working on them, jet change. Try tapping on the bowl with screwdriver handle
  9. That's because this is most recent thread with key word "serval" Expand search.
  10. Maybe clean/refresh chassis ground
  11. operative word in description "WAS" If it had a SB , Caddy North Star, or SC3800 maybe. Stock drive train, no way
  12. Did you remove emulsion tube when you cleaned carbs? Both needles same and same clip?
  13. That looks like it would be a hoot to drive.
  14. Coil and plug caps ohm correctly?
  15. I'll do logic for $200 You can't see the protrusion on backside nor holes in seat, therefore appearing flat ?
  16. Nice sentence structure.
  17. THANKS !! Leaning towards these as a way to "fix" a fucked engine I have.
  18. I may have missed it, but is this high port or low ??
  19. X-1,000
  20. For Locohomo to suggest these over Ohtsu says something.
×
×
  • Create New...