Bansh-eman

anyone else seen anything?

Pro Elite Nerf Bars $80 IMS Tank ( NO cap or petcock ) $175 Aluminum Bumper $50 Stock Coil $50 Lower Motor Mounts $15 Eibach 8 Inch Coil over Rear Spring 0800-225-0375, Used but good condition. $30 GB Racing CDI Relocator Plate, small damage under the plate where I had to cut off a bolt that got stuck. $15 If you wish to use Paypal You add 3% for fees. If not I will take money orders. All parts plus shipping.

heres a link to the CR 158 link im still looking for the CR 121

they are ez to install, there are a ton of them out there. just checkout ebay.

id look into some 20-10-8 10 paddles or some 20-11-8 10 paddles. haulers of course not extremes

its your TORS ( Throttle Over Ride System) you can get rid of it, there is a tors removale kit you need to get that will have new caps and parts you need to drill into the carbs to install air screws..

might be interested in the intake and 39 pwk's and the rear coil over

my bike is parted out right now, im going through a rebuild and replacing a shit ton of parts that got stolen. im running marvin shaw hill shooters all around. ill gt some picts of the a arms, but i took off all the hardwear on them cause im sending them out to get chromed. so all the balljoints and hemi's are taken off.

and they will screw into the existing hard lines? what they run you? and you got any picts?

it should spin but not freely, it should have some tension on it.

anyone seen anything that ties into the harewear ?

i got a set play/dune ported for a 4mil from alba, comes with wiesco pro lite 795 pistons, has extended studs installed. has 5 trips on them. 64mm bore and not anywhere close to needing to be bored. 400 plus shipping

What are you guys using that will tie into the stock hard brake lines? I want to keep the hard lines and just replace the old black lines to the calipers. what are you guys using that will tie right in?

same as above, i got a polished you pay the ride.

i got them, they are nice. i wasnt too sure on the lower shock mounts becasue they are only wleded on the out side, so i sent him a message and he said they only to one side because the pressure is foring down on the tabs not out wards, i asked if he has had any issues with them and he told me he has had 0 problems. other then that one stop i was owrried about they are perfect. awsome craftmans ship. if your going to buy some get them while he has them on sale.

it comes with everything but new tierod ends. you have to moddify 450 shocks to fit them.

that would be a 69mm bore and a 4mil crank. i havent seen anything like that for sale.

i got mine in today... they look good. only one spot i would kinda lick welded a little better but its just cause im paranoid it would also be nice if the lower had zerks.

yea im not too damn happy, i made alot of plans around this weekend becasue these fuker said weeks ago that they wanted to lock this on, well go fukin figure they bitch out at the last sec with lame fuking excuses

im trying to get ahold of everyone that was supposed to go but it looks like they are all flaking out... not even sure ill end up going now.i was going to leave tonigh but i couldnt get anyone on the phone. now i guess we will see about going tomorrow if anyone hasnt bitched out completly

wow thats insane.

bada pm sent

in half? wtf did you do? jump off a cliff? i beat the shit out of mine and it had 0 issues.

i snatched up a dominator for 200