Jump to content

375hp banshees

HQ Premium Member
  • Posts

    6,882
  • Joined

  • Last visited

  • Days Won

    209

Everything posted by 375hp banshees

  1. I've been patiently waiting for my clear coat to get bad enough that it will come off. this is before and after by doing nothing but scraping it with my finger nail Sent from my XT1585 using Tapatalk
  2. It's better if you do, don't know if cam sells them, if not f.a.s.t does
  3. Make sure Your air filters aren't dirty or over oiled too
  4. easy swap if u have 1...they're all fine... till they aren't
  5. Iirc '01 & up had p.brake The switch was part of your clutch lever if the brake is on, its grounded so you don't have enough power to move with brake on, by limiting your RPMs . that green with yellow stripe signal wire, goes from that switch, to CDI & if grounded will tell cdi to limit Did you have this problem before your cover fell off?
  6. The only blue I see is voltage regulator and light switch going to brake/tail light
  7. Green with yellow stripe. Does it limit Rpms free reving?
  8. Sent from my XT1585 using Tapatalk
  9. Never mind didn't see '97
  10. Make sure g/y wire to Parking brake isn't grounded Goes from cdi to switch on clutch lever which grounds it
  11. White one sounded lean...lean popping at vid start
  12. Nerf bar or pegs I'm looking for nerfs Sent from my XT1585 using Tapatalk
  13. You'll be 1/2 way to your reeds doing a leak down test. Might not hurt to look @ them too? Sent from my XT1585 using Tapatalk
  14. do a leak down and make sure you don't have a leak but...Not uncommon treat each cylinder like an individual motor . you don't have to have the same jets in each carburetor. just monitor ,so if it was something stuck in the carburetor and it becomes unstuck it'll change (but more than likely, become rich, so shouldn't hurt) Two other common problems are choke tube left out, slides in backwards and over oiled filters Single air filter? If not swap those LtoR n see if it follows Sent from my XT1585 using Tapatalk
  15. Vito's= rattle can ray...DONOT Sent from my XT1585 using Tapatalk
  16. You can, but it's a waste, but if that's all you have? you're going to lose some bottom end and won't be ideal , but you can tune it to run okay
  17. Matt just did mine, great guy! Sent from my XT1585 using Tapatalk
  18. Took him seven years ...but yeah it's fixed
  19. If you're not getting into your power band ,you will be disappointed. Does it break up at all free reving.
  20. ...so not junk, just drag only...i can't argue that Sent from my XT1585 using Tapatalk
  21. No he jelly Sent from my XT1585 using Tapatalk
  22. Just the top? Still tapered or straight?
  23. Sober yet? Bump
×
×
  • Create New...