375hp banshees

Check your pm's Sent from my SM-A505U using Tapatalk

^^ or. HMFICdontsteelmysheepics@[email protected] Sent from my SM-A505U using Tapatalk

Thats a whole different problem Sent from my SM-A505U using Tapatalk

It's leaking out the overflow right? Did you check off the stuff on the link i posted... did you put a new needle and seat with sealing ring, inspect float & set properly, fuel cap vents properly, check for leak with bowl off...? Turn the fuel off ( or open drain) to keep level below overflow tube & see if it runs better with out over flowing? Sent from my SM-A505U using Tapatalk

^^^ doesnt havez enough powaz to tell Sent from my SM-A505U using Tapatalk

Joe molinari at joes atv performance & fab.you can text him @ 619-370-0388 Sent from my SM-A505U using Tapatalk

Remove the lock nut (temporarily ! ). screw in farther & see if that helps. Then either shave boss down more > or adj. idle by the cable Sent from my SM-A505U using Tapatalk

Stock carbs w/ tors delete? Bosses probably werent shaved to make them go deeper before bottoming out look here for over flow issue https://www.bansheehq.com/forums/index.php?/topic/192426-carb-replacement/ Sent from my SM-A505U using Tapatalk

Yes, And inspect your overflow tube but I would loosen your cap 1st, you might be over pressurizing the seats. Make sure you put the correct bowl back on the correct carb, they are different! Sent from my SM-A505U using Tapatalk

Leave everything hooked up hold the float up with something & see where it leaks from...that should be the only place tho, unless your overflow tube is busted? Your cap is venting good( leave it loose & see if that does it 1st )

New seat with new sealing ring?

iirc stock stroke , long rod...if your ported to match

Or Ohio?

R u from flint too !!! Sent from my SM-A505U using Tapatalk

Man thanks, i've been waiting two months to ride

From 2k7cheeta to driveline? Sent from my SM-A505U using Tapatalk

Yes bearing could be your problem. Usually its just an adjustment issue. Has it been getting worse or been hard since you got it? Shifts hard all the time, or under a load? Whats hp difference between this one & last one? Sent from my SM-A505U using Tapatalk

Hike Sent from my SM-A505U using Tapatalk

Good thing you got pincil legs, those cpi's look like they'd melt DDQ's legs right through the...muscle Sent from my SM-A505U using Tapatalk

Oh duh utter BHP Sent from my SM-A505U using Tapatalk

Bubbas House of Power port job?

Filters over oiled, did you re jet for pods? Sent from my SM-A505U using Tapatalk

& keep the niche cylinders? Sent from my SM-A505U using Tapatalk