Jump to content

trickedcarbine

HQ Premium Member
 View Profile  See their activity

  • Posts

    15,233

  • Joined

  • Last visited

  • Days Won

    165

 Content Type 

Everything posted by trickedcarbine

  1. trickedcarbine
    ^ yessir. That's a cheap trip to the hardware store that could save you from a rebuild.
  2. trickedcarbine
    What is current factory 43 contact? They're in Canuckia right?
  3. trickedcarbine
    ^ valid point. About $300-350 difference. Worth it if you got it.
  4. trickedcarbine
    Stock cross over tube.
  5. trickedcarbine
    Don't hurt his feelings.
  6. trickedcarbine
    Clean it up with emery cloth if you can without removing to much material. Maybe even put it in a dril and pinch a Scotch Brite around it and spin it for about 10 seconds.
  7. trickedcarbine
    You won't see any difference going to CPI In Frames. In fact, maybe even less RPM. If you wanna try and get some more RPM, the shearers are the way to go. But they will not get a big fella like you moving out of the hole like the CPI's.
  8. trickedcarbine
    Haha!
  9. trickedcarbine
    ^ CS
  10. trickedcarbine
    What pipes/carbs are you running now? What do you weigh, what type of riding, and what do you like/dislike about the current set up?
  11. trickedcarbine
    Nah, any one that has dealt with him said it'll take a bit, but it'll get here. I was just curious about RRL's as I was looking at a used one a while back and was gonna swoop it up but was to slow.
  12. trickedcarbine
    Last I checked they^ were the same brand and part number.
  13. trickedcarbine
    Who did you pick that up from?
  14. trickedcarbine
    I'll see if I can find old charts. Almost all of them had it and some folks just couldn't get it to iron out.
  15. trickedcarbine
    TDR has a decent price on them.
  16. trickedcarbine
    Two max loads. Full clip.
  17. trickedcarbine
    Helical gears side load the bearing. Not good for TZ bearings.
  18. trickedcarbine
    Yes. There are a few guys running them on helical gears though.
  19. trickedcarbine
    Not for The flat track bike. Sent from my iPhone using Tapatalk
  20. trickedcarbine
    Turbo Chassis is doing them. Recently started doing a light weight OEM look alike with single arm set up.
  21. trickedcarbine
    Solid 4mil with -2 arm. Currently about to be running a 521cc motor on a -2 arm as well.
  22. trickedcarbine
    Apparently can't figure out how to quote either...
  23. trickedcarbine
    ^ First sentence sort of explains it all.
  24. trickedcarbine
    Cascade is one of the originators of legit banshee parts distribution.
  25. trickedcarbine
    I realize this is an old thread, are you still doing hubs? If like to get a set done. Any ideas on lightening the rears up?

BHQ Quick Links

×
×
  • Create New...