Animalman294

Unless there is really something wrong with the crank seal, reeds, or the rings.............

Yeah, I used AV gas, but when I was down around 150...................

Yeah, I heard that too thats why it stuck in my head screamin' banshee..............

Yeah, if that can be posted I'd be interested too................. :thumbsup:

Boost bottle!!!!!!!!!!!?????????, you just had to go there didn't ya. Well, you were off to a good start.................... :yelrotflmao: :yelrotflmao: :yelrotflmao:

I've heard good things about the TCS shocks, I might have to look into those..........

Looks good man..............

Yeah, I went and got one of those specialty tools to perform those specific kinds of jobs. I got the icepick out of the kitchen works great every time.............. :thumbsup:

Yeah, there shouldn't be any problems with the motor mounts, but the jumpin' around may have just tweaked something which could be fixed with adjusting the pipe hanger. When I took my stock hangers off to remove my motor I noticed that the rubber between the two piece's of metal that make up the hanger had ripped away from both sides. So I used superglue and hopefully that will hold for a while until I get different hangers..............

Yep, a little preparation now saves you so much time and headache later................ :thumbsup:

Yeah, I have seen some that looked really cool.................. :thumbsup:

I seriously doubt that Yamaha named there best two stroke sport quad after a female ghost fairy or a mermaid................ :shoothead:

Welcome to the addiction. I hope your credit card has a high limit................. :yelrotflmao:

For those of us that don't know, can you fill in the story................ :shrug:

Yeah, I always thought it was named after a "screaming banshee", which is what the white settler's back in the old west called the attacking indians.............

Well after all it is e-bay, so some idiot will buy it and wonder why it doesn't fit...........

Yeah, you can special order things from Rocky Mountain ATV, you may also try Motosport they have some pretty good prices and also may be able to get you your offsets...........

Yeah, when I get tools I get two of everything one set for home and one set I keep in my gear box. I keep the standard bubble gum and bailing wire to mickey mouse something so it doesn't ruin the weekend.............. :yelrotflmao:

Welcome to the HQ............... Just a side note make sure you have enough fuel to make the eight hour run, because shee's don't get the fuel mileage that a four poke gets................. :thumbsup:

:: :shoothead:

Yeah the floats are either set too high, or the seats are not sealing which allows the tube coming down to the carbs to drain down to the bowls overflowing them................ the carbs are pretty straight forward, just take one apart at a time, just in case you get confused or cant figure out where something goes.............. :thumbsup:

Yeah, I don't think I wuould be going below a 13 in front either especially with your mods...........

I'd also try the rejetting to see if that helps. Get some starting fluid and spray it around the intake, the head, and anywhere else you think there could be an air leak and when it reves up you know it is sucking air there............... :thumbsup:

You should be fine with 20cc domes and +4 timing advance. I ran mine that way for about a year until I got the cubby, but do a compression check after you put it at +4 to double check on the pump gas. I ran 50/50 pump gas and AV gas - 100LL and it gave it more pep.............. :thumbsup:

Yeah, the subframe is usually the place where you may also see if the frame is bent, but look at the welds too............... :thumbsup: