375hp banshees

Are all round house bearing carriers the same? ie can i put my 40mm shaft in my stock size axle carrier by just changing bearings & seals? ...All banshee stuff of course

It doesn't appear to be Ray, but I'd be very carefull of anything that comes out of Macomb, Mi. There was somebody making those tho, seems like ayesully knows him?

https://www.bansheehq.com/forums/index.php?/topic/188396-banshee-cylinder-information-thread/

Yeah it's the one in the quad that goes bad, from sitting

Yep, i tried that no toil brand foam style on the polaris...same thing Everybody's gone to cheap products these days. They would always break down, but a lot quicker now it seems.

I'd rather keep polishing it than spray bomb it

You should find out what it was, for you next time & post here for others

Cant help ya there, running stock, somebody will chime in, and as caleb said, water wetter or engine ice instead of coolant... helps

https://mullengineering.com/rt/ Sent from my SM-A505U using Tapatalk

Water pump impeller

Lol ...chill go have a cold one... oh wait🍻

Oh ok it's only 90° there & 92° here...but what ever... good luck

Stock radiator should be fine, unless you're idling around with no air flow, or you have other issues

Hez gotta leak damnit Tapatalk ftmfw Sent from my SM-A505U using Tapatalk

Usually the crack isnt leaking ( usually cracks around the bolts). there is a round piece on the back that has an oring on the o.d. that seals it to the case. You can lean it over to keep oil away & remove white piece & match oring up locally or buy a new cover with oring . they sell billet ones ( you cant see it but they hold up better) did you make sure your vent lines were open? Sent from my SM-A505U using Tapatalk

Theres one by water pump & one at rear motor mount. Not saying they're leaking ,but if not venting properly it will build up pressure & cause leaks. if your saver bolts to the 3 bolt ( white kinda triangular) plug by sprocket , it is sealed by an o-ring or could be sprocket seal, or vent/hose by waterpump

Oring behind it leaking? Vents, venting properly? Sent from my SM-A505U using Tapatalk

Not sure, but it only takes ...one

Bump

I'd say those are safe guess' @sea level i'm safely at 155 with 35's Was @ 340-360 w stock carbs & cpi's, depending on filters

How much is It leaking? Sent from my SM-A505U using Tapatalk

Around crank I Assume. I don't Remember if you could put a speedy sleeve In the area or not . even if it's Not Grooved, it at least will give you a little larger OD and Might seal? Sent from my SM-A505U using Tapatalk

What brand seal? What happens if you spin crank over while testing it? Sent from my SM-A505U using Tapatalk

You grease seal i.d. during install? Sent from my SM-A505U using Tapatalk

I bet you would Bump