Phelps

as far as i know there is not a "dedicated" day that everyone will be racing... ppl will be playing on the strip all weekend just like normal.

i asked around several times and i was always quoted damn near the same price. savings of like 25 bucks...... if you find a good deal on a diy kit let me know.

(J nut)

BANSHEE (after owning 2, it's kinda a requirement to spell it right) CDI BOX is the key on?

in my area they only go for around 600-1000 depending on what goodies they have.

6 if you plan on trial/dune riding. 8 if your going to be drag racing.

WHY ARE WE SCREAMING?! send the cylinders in to a sponsor and let them do their job. do not order pistons, you will only be risking losing/wasting money on a set they may, or may not fit/work.

flames for a flamer....

i am running a 421 cub on alky and all i am using is stock springs and clutches.....

please stick this mods. one less question to answer.

for instance in the fs section. when someone post pic's it never fails. the first tard to want one of the items quotes the whole damn first post with 10 pic's, just to say..." dibs on the...."

i don't understand the question. the O rings will only go in one spot i believe. just sit the O rings in the tracks and you will figure out where each one goes. if there is a groove/channel there should be a O ring there. brown is high temp/high pressure O rings so they always go on the combustion side of the dome.

brown goes between the domes and cylinders.

i have a good one for 60 shipped

i have no clue rather they do, or don't but anyone can do a good clean up with the right tools. lol hell i have a stage one port too i guess. after all i did go in and massage a few ports that had humps, casting etc.

oof's are fine, i just don't like loud pipes and (i have been told) if's retain just a tiny bit of mid hit. yes you are drag racing but that (tiny little bog) you get when you launch seems to go away with if's.. yes they have silenced oof's, but make sure you at least get the good looking silenced shears. not the kind that looks like the silencer has been just stuck on lol

sb shearer if's

up!!

if the right side is 0 then i would assume something pretty serious happened. i would tear it apart and have your local machine shop/builder find out what is going to need to be done. might need a cylinder.....

what retard did the grinding on the gasket surfaces top/bottom of the cylinders? the cylinder walls look like shit and that's why everyone should ask for detailed pic's before they purchase something like this. BAD 350 idk how much you sold these for, but i don't know how you could have had a clear mind about it if you charged over 50 bucks. just my opinion though...

did you install the bushings?

jd you can't even tighten a chain, how the hell can you measure a port height? post pic's if you are going to accuse him of selling bad parts. use a white sheet of paper below the cylinders for best lighting of the walls.

ttt

up

110-140 depending on your elevation. if you have a stock head i would suggest putting it back on.