fastrthnu

ingersol rand makes a bad ass battery impact. my pneumatic is a 1/2 blue point. I use them alot though so I dont buy no fucking crapsman husky busted bs that break all the time. that got old.

going from 28mm to 30mm with no other engine alterations except new pods, think my mains should be the same or a size or 2 bigger? I was already at 370 with 28`s. 370 was on the rich side, but now that its cooler, it would be dead on with my previous configuration.

need some for std pods

need a pair of pod outerwears for k&n ru0210 filters. pref black or yellow.

Ill check it out,. thanks.

looking for a reliable place to get a pair of pods and outers new or in good used con that I can pay with paypal for 30mm carbs

uhm yea go ahead! those are great! I cant imagine why someone would sell those so cheap either. must be like a fuckin charity or somethin. see if you can get them in another color though,.. that color is freakin gay!!!! those are kinda like these that I found but better and cheaper.......... yea you like them huh, yea buddy!

no, Im saying the oval adaptor you have wont work with the filter you put a link down too. that filter goes to a DIFFERENT setup that doesnt utilize the airbox and adaptor that you have now.

then no, that filter is made for the 2/1 setup that goes directly onto the carbs, not in the airbox. that is not an airbox filter. not for a banshee airbox anyways unless there is a round adaptor plate made Ive never seen or heard of.

so you have the pro design aluminum adaptor?

I dont know what I was saying, I was just trying to sound confusing too.

then the lever is prob not seated all the way. take you preasure plate off and pull the pushrod out a bit and see if it drops down more. the part the cable hooks into should be level with the center of where the tip of the cable mount/clamp down in the middle of the case is.

the adaptor that has 2 is the one with the 2 in 1 and the foam goes over the one with 2 so you have to get one with for 2 so that the 2 work wih one.

pfff 660`s are sellin here for 1200-1500!

I want them! sending PM!

hahahahahahaaaa :yelrotflmao:

yep

sounds like damage from the 200`s.

$40 shipped These are brand new newer used. to carb posting.... http://www.bansheehq.com/forums/index.php?showtopic=104294

If I have a job by then Ill be in even if its in Ocala. I havent been out in a few months and Im dyin.

this style in chrome or black/flat black is the only one that would ever go on mine you could always go with the one with the mouth and teeth!!!! GAGAYYYYYY!! I think it looks better without one than with a stock one.

sending PM

what! none of you have done that. I made a castor board with 2 mini straps (used for supporting electrical conduit) that the grab bar snaps in and out of. Just watch you have vent tubes hooked up from your case or youll have a harley davidson stain on the floor under it.

I have black labels up front and I have beat the fuck out of them. I ride pretty hard though. I beat up the last set of itp`s I had too so bad the bead wouldnt seal no matter how I tried to beat them into round. red label might be the best bet. My next set provided I have any money will be black itp baja`s. stock wheels are prob more rigid than blue or black labels with the rolled lips. Aluminum is strong and light, but not when its that thin.