superchicken

tyguy71 arent you the guy who blew his bottom end and now has oil burning through the cases are you.i wouldnt want to see a fellow hqer get suckered into a fucked up bike

i dont think thats a no2 bottle.i think thats the gas tank. crazy shit though

your theory of being all the bike is far from the truth.i speak from experiance.i have got a 75 hp. shee but in the first time i dragged her against a piped banshee,i lost two out of tthree times.why because i couldnt get any traction on it.but the third time i hung my ass over the rear tires and hooked up to kill him by 10 bike lenghts.like the other guys said,missed shifts,rider error plays a big difference in dragging.look at top fuel dragsters,they all have there days of winning and losing because its 50% engine and 50% driver.end of story

i give you a c- for effort.you could have pulled the wiring harness,vent line,brake lines to give it a nice clean look.looks ghetto to me.but to each there own.a nice clean job will increase the resale value also

i love those nerfs.

id like to see an optional beer dispencer on it

i know that four stroke packing seems to be very dense,and two stoke packing is a looser mix of material.not sure why the difference

did you do it today?were both in jersy and it was pretty moist out today.humidity has alot to do with pait dulling out.spay them again and get them inside were its warm and dry.it helps to put on a nice heavy even coat,borderline too heavy.wile spraying it look at an angle to catch the glare to see

i think your an ass.i wasnt swayed by the clark boys,in fact i have my own opinions on them but this isnt the time or place to get into that.rocket pipes do make power,the finish on them is second to none.just becuase there not well know like cpi's or shearers dosnt mean there junk.it sounds like your a mindless lemming following the heard thats convinced that the other pipes are the best.dare to be different,or are you just afraid that your buddys will make fun of you.

is your oil level dropping when you check the dip stick? maybe your just way rich

ive always used either yamabond or three bond grey when i do the cases.now i do know after you assemble every thing and get her running ,the oil does go a little low the first few times you go riding,i think because it lays up on the tranny gear shelfs.so,why exacly do you think its burning oil?

na not for 22's and steel.i thought you had some 20's you were going to email me pics of?

opinions are like assholes,everone has one as for rockets i love my set.never had it dynoed but they make the power i want and respond in a manner wich i like. ultimately thats what every one needs to base there decision on pipes on. on different engine combo's,and porting of course different pipes are going to different power.there is no magic pipe.if loco had the most hp with rockets on the dyno over other pipes,well they worked best on his engine.the same will not be true for every one that buys a set of rockets. if you think that it will,your sadly mistaken.

maybe a 270ish main with the airbox lid on.300 off.3rd clip down and 2 turns on the air scews.that should be a good starting point.make sure the carbs are synced ,or shee wont idle that good.run her and see if it breaks up or bogs.after running her on a high speed pass shut her down and look at the plugs

all i know is that if i was on one id need a milk crate to reach the ground.i could never stop,till i found a tree to lean against

i like that set up! was there any problems with the set up on your banshee.how reliable are they?whats the egt on a properly tuned banshee?

if your losing oil the seals fucked,get over it and split the cases.

very impressive dune girl

i have an identical set up,well maby if the porting is the same and i run 17-41with a 20 inch tire

coil

AMen! Jim, but it sounds if you want a nice all around engine with occasional trail riding(tight technical) cubs may be the way to go.depends on what,and how you want the engine to perform. scott

4. always carry a roll of toilet paper in your truck

primary drive 520 rd self cleaning pro chain - 7800 i have that one,got it from rocky mnt.just make sure you keep it well lubed or the links start to bind a little.

thats why i bought mine!!

ok there up for sale now.pm offers.shipping is going to be around 20 bills