Shifter Seal Leaking....again.

[doug]

Second shot.

[trickedcarbine]

Still seeing damage.

[doug]

ok, I've contacted JDS.

 

Thanks for the help guys.  I hope this fixes it.

[sleeper06]

There's a very small tolerance with an oring fit could be worn and your eyes still not picking it up

[doug]

Thanks for all the help guys.

 

I've messaged JDS to find out where the part is on their site - does anyone have a direct link?  I don't even know what this part is called or what the heck it does.

 

Thanks.

[bigweav81]

My bad lol. Fast racing sells them.......pretty sure anyways. I honestly thought jds made some at one point. Maybe not.

 

Sent from my SM-S820L using Tapatalk

Edited February 2, 2017 by bigweav81

[hoppedupandcutdown]

http://www.ebay.com/itm/BANSHEE-DRAG-RACING-BILLET-NEUTRAL-SWITCH-COVER-MFG-by-Mattoon-Machine-/222396448083?hash=item33c7dc7d53:g:Km0AAOSwmrlUwYrk&vxp=mtr

[hoppedupandcutdown]

http://www.ebay.com/itm/Chariot-Banshee-Neutral-Switch-Cover-Fine-Machined-Finish-Billet-Aluminum-/252721867362?hash=item3ad765aa62:g:VH0AAOSw241Yd8yB&vxp=mtr

[m671054]

I cant remember if those screw holes are blind or go through into the trans cavity, if they go through then those screws need sealant like locktight. Also make sure the shift shaft plugs are intact

[n2otoofast4u]

http://www.ebay.com/itm/BANSHEE-DRAG-RACING-BILLET-NEUTRAL-SWITCH-COVER-MFG-by-Mattoon-Machine-/222396448083?hash=item33c7dc7d53:g:Km0AAOSwmrlUwYrk&vxp=mtr

Buy this one!

[Strm Trpr]

I cant remember if those screw holes are blind or go through into the trans cavity, if they go through then those screws need sealant like locktight. Also make sure the shift shaft plugs are intact

 

Just adding to your comment, and not bashing, just trying to help the OP.

I verified with my engine builder that the neutral safety switch cover holes do not go thru and the screws do not need sealant or loctite.

[doug]

Guys, would this have broken because I tightened up my case saver bolts too tight?

[m671054]

Just adding to your comment, and not bashing, just trying to help the OP.

I verified with my engine builder that the neutral safety switch cover holes do not go thru and the screws do not need sealant or loctite.

maybe I was picturing billet cases? Now I have to check this weekend or it will drive me nuts

[doug]

Hi guys, I got my new billet part and installed it.  No leaking so far.  I wonder if the cracking had something to do with the case saver and maybe I over torqued it.  Thanks for the help.