spdrcr Posted February 10, 2016 Report Posted February 10, 2016 what do you spark plug boots ohm out at? trim the off 1/4 of wire to make sure it is getting a good connection. check the wires for damage. Quote
R.R-1.1993 Posted February 10, 2016 Author Report Posted February 10, 2016 The coil is brand new but im gna check em rite now Quote
R.R-1.1993 Posted February 10, 2016 Author Report Posted February 10, 2016 Is it possible to have spark but not see it I sware i kikd it while thumb on top of plug and it gave a lil shok??my buddy tried it to said definetly pulse Quote
sheerider11 Posted February 10, 2016 Report Posted February 10, 2016 It can be a weak spark. Did you ohm the coil and caps? Quote
R.R-1.1993 Posted February 10, 2016 Author Report Posted February 10, 2016 I have not my ohm readers jakd im gng for 1 in the mornin What is it suppose to read And how do u check them?? Quote
Larry's Shee Posted February 10, 2016 Report Posted February 10, 2016 If you can't see the spark it's probably not strong enough. Sounds like it's time to get a Clymers or find the PDF Manual on this forum. Quote
R.R-1.1993 Posted February 10, 2016 Author Report Posted February 10, 2016 Anybody know how to set pickup gap on Pik up coil W out the tool of course i loosned it and i got spark but nothing again Quote
sheerider11 Posted February 10, 2016 Report Posted February 10, 2016 Anybody know how to set pickup gap on Pik up coil W out the tool of course i loosned it and i got spark but nothing again you said it's already a business card. Quote
R.R-1.1993 Posted February 10, 2016 Author Report Posted February 10, 2016 Ya but is that the rite gap??? Quote
hoppedupandcutdown Posted February 10, 2016 Report Posted February 10, 2016 Pickup coil gap: 0.015"-0.020" http://bansheehq.com/forums/index.php?/topic/133650-banshee-electrical-faq/ 1 Quote
R.R-1.1993 Posted February 10, 2016 Author Report Posted February 10, 2016 How can i measure that w out tool??? Quote
hoppedupandcutdown Posted February 10, 2016 Report Posted February 10, 2016 I just measured 5 different business cards from my desk drawer... .011" to .014" 1 Quote
R.R-1.1993 Posted February 10, 2016 Author Report Posted February 10, 2016 I just measured 5 different business cards from my desk drawer... .011" to .014" Quote
R.R-1.1993 Posted February 10, 2016 Author Report Posted February 10, 2016 So the card is not the rite measurement for the pik up Quote
hoppedupandcutdown Posted February 10, 2016 Report Posted February 10, 2016 A card in there loosely, will be fine. But not to loose. Not tight either. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.