BAMF87

I might have to call them, just didn't want to spend that much

Guys where's a good place to get race gas in Tucson or I can get it in Yuma on the the way to Gordon's. I think Loves in Yuma has it for 8.50 a gal, anywhere cheaper?

Who ported the dune jugs and also the 4mio jugs

Thanks I'm not too sure where to get higher octane.

Guys I'm.about to.get a cool head and was wondering what dome size to get. My mods are fmf fattys, +4 timing, chariot reeds, 28mm pwks with pods. My elevation is 2000-2500 but I also go to Gordon's well a few times a year which is close to sea level. Oh and 91 octane gas with castor 927 mix 32:1.

Shocks and arms sold, still have pro design with filter.

Who ported the jugs?

I have a pro design adaptor with filter and boots for sale 40$ shipped Stock front shocks 30$ plus shipping Stock front a-arms 60$ shipped no pics of arms yet

Yea mine touches the actuator but doesn't seem to affect it

I just put keihin pwk carbs on my bike and got it jetted. It runs great but I noticed that the left carb is leaking fuel from the bottom vent like on the bowl. Is this a float height problem and if so where should they be set. 2000 ask, chariot reeds, fmf fattys, +4 timing. 150 main 45 pilot.

Just got mine powdercoated and I can't believe I even considered painting it. The powder is awesome and durable. Too bad I forgot.to.tell the coater to cover my vin

I was considering full flight but went with alba gulf wings. They are great and tough. Everyone loves stellar also.

1) What type of aftermarket exhaust do you have? Fmf Fattys PC2s 2) What type of airfilter do you have? UNI pods w/ outerwears 3) Are you a)running a stock airbox with lid stock airbox with NO lid c) Stock airbox with vents d) no airbox at all:.........No airbox. 4) What is your elevation? 2000-3000 5) What size pilot jets are you using? 45 6) What size main jets are you using? 150 7) What temperature is your Banshee jetted for? 80-90 8) Do you have a port job? No 9) What kind of carbs? Keihin 28mm 10) What size carbs? 28mm

Ok pulled them open and the needles are jjh just need to pico up some pilots and mains.

Ok thanks ill start there

I just got some used keihin pwks 28mm with pods, they already have a needle in them, what size mains and pilots should I use. 2000asl here fmf fattys, chariot reeds. That's all for mods.

Ok so they are supposed to be there? Wasn't sure.

They aren't threaded holes just two dime sized holes.

I'm talking on the bottom of the cases there are two open holes.

What exactly are they called

Ok looked at the bike closer and no coolant in cylinders I guess the angle I was holding my light made the reeds look green. BUT the two plugs on the very bottom of the motor are, well.........gone! Where can I get new plugs for it.

Thx for the fast replies guys due to work it'll be a few days before I can work on it good. I'll advise what I find out.

U mean the hose with the plastic end on it that pops into the case by the rear mounts? It's connected not sure if it leaked there ill check when I get home

Thx ill check that, but it was like squirting out of the area that the tranny sprocket stick out, like it pressured up