banshee(911)

fast shipping and well packaged a++++++++++ would do buisness again verry satisfied thanx john

how much for the clutch and stator cover?if you wanna just sell the covers im interested pm me a price

jeff @ F.A.S.T. he has the best clutch

if you send them to [email protected] ill post them 4 ya

well hope you figure it out ive got the same sound after been to two builders still there ive replaced the tranny bearings i can hold a big screwdriver to the sprocket and hear the noise in there well my builder told me i needed new cases so i picked some up from nyuk but if thats not it then im going to b replacing my basket as well but neways good luck

if sale falls through id take em

i also have the vitos 4 mill with the stock length rods if i had to do it all over again id go with the long rod just kuz you cant run blaster pistons with the stock length rod 4 mill so your gonna loose that but you can run the stock banshee pistons but the blaster pistons are flater on the top there for more ponies but its up to you the pistons you have to run are the 513 pistons

ok i loosened the motor mounts jacked the motor and now every things fine thanx

is the axel strait pics of axel

i also run the 34mm pj,s on my cub now but i had them on ported cylinders and it ran awsome also but i had the toomy t5,s with open pods

heres some pics http://i283.photobucket.com/albums/kk282/b...04/100_0223.jpg http://i283.photobucket.com/albums/kk282/b...04/100_0222.jpg http://i283.photobucket.com/albums/kk282/b...04/100_0221.jpg http://i283.photobucket.com/albums/kk282/b...04/100_0220.jpg

ok well i recently bought some shearer big bore pipes and they dont fit all that good they are just shy of going on all the way and the way there mounted right now they law right on the framethe bottom of the pipes are resting on the frame @ the exaust port was wondering if anyone had to raise the motor a lil to get them to fit proper any info would b greatly appreciated ps ill post some pics soon thanx Ray

damn that was quick

where you @ im on my way

ive got a set of 80 over ported cylinders and a spacer plate for 250 if interested pm me

tell her to have it there

i agree i think a patch is the way to go although ive seen patches with plugs on them also

i wouldnt mind it either bet hes got some good pointers

boost bottles make great pencil holders

well good luck hope it works uot for ya

ttt

got any good engine cases?

bump for sweet swinger

do you have to run a pump with theses carbs

ok 250.00 some one needs these make me an offer