Matt96shee

gotta split the cases this weekend to get in to the trans, i think i have a bent fork or two. how are the rods the shift forks ride on held in the case? from pics on here it looks like they are pressed in...is this the case? thanks guys, matt

bought a coil from him. he kept me updated on when it shipped and it arrived exactly when he said. Thanks man!

hey jeep, i sent you a pm w/offer, did you get it? does no reply me "no"?

how much like it sits?

PM sent here too!

sent you a pm, how much as a roller?

pics to [email protected] thanks!

if you part the engine i'd be interested in the case

what's the specs on the stator?

pics? year? price?

hey guys, i may be out in oregon for a few months starting in may. are there any stickers/permits i'd need to go riding in any of these spots?

just turned 30 here. rode a 250 quadracer in highschool. i finally got a banshee a few months ago. i have plenty of trails and dunes left in me!

do you have the fenders too?

my brother just bought one of those for his garage. i must say, it's the cat's ass for front tires. but, it took both of us to wrestle on a set of 22" blackwaters. it does have a bead breaker you just can't see it in that picture.

Hey guys, I bought a complete RZ350 engine a few weeks ago. It needs bored, possibly just a hone, as the compression is down around 95psi in both jugs. I'm still researching builders on here and procrastinating. My question is, when I send out the jugs do the powervalves need to stay in? I haven't taken the engine apart yet so its probably very obvious what the answer is. Thanks, Matt

how do you set the floats? i knew that was my problem but don't really see an adjustment. thanks, matt

i had the same problem over the weekend....pulled the head and found it was not sealed very well. stuck a new head gasket on, torqued them down and it ran fine. i suspected a head gasket when i found some oil in the radiator....pull your radiator cap and check it.

Could one of you guys post a pic of your carbs with the idle screws installed? Thanks, Matt

i'll second that....bought some pipes/silencers from him....they look like new!

hey man, I've watched auctions for your motor 2-3 times now.....you say BIN for $1200 in the auction but there's no BIN and no reserve. Do you just not sell it to the high bidder? I'd like to bid on it but don't really understand what you're trying to accomplish. Thanks, Matt

where are you and send me some pics! Matt

pics of the nerf bars please???

Looks good man! I'm testing the Rhino Lining look on my plastic...it was beat up anyways so I figured what the heck.

soooo....if that fitting came out and oil came out the hole, would that be bad? should i keep digging into the motor? oh, how does that fitting go in the cover? is it threaded?

Thanks man! What's it venting though? Just excess pressure? Does it just go up the frame and vent to the atmosphere or to somewhere else on the motor? There's 2 screw holes on each side of it, what are those for? Matt