2002 banshee one side fire

[375hp banshees]

11 hours ago, Fordmaster101 said:

 

*Run

If you spray it & it tries, then its firing just not running.

[Fordmaster101]

I can spray alittle in both carbs . Kick it it's starts runs for about 5-13 sec both high ish rpm and low ish rpm depending on how much throttle.  But than stalls out and won't start unless sprayed again 

[375hp banshees]

Youre not getting fuel to the cylinder then. see if your bowls are filling if so your jets are plugged, if not your float needle/ seat ( fuel inlet isnt ) is plugged / inop.

Sent from my SM-A505U using Tapatalk

[Fordmaster101]

Jets keep getting clogged. Would seafoam work ? I use in cars and lawn mowers . Could I just fill the carbs with that let it sit than run it clean ,just like normal application .would that clear it all up 

[375hp banshees]

Never used it... depends on source

Sent from my SM-A505U using Tapatalk

[Qliphoth]

On 3/19/2022 at 10:49 PM, Fordmaster101 said:

Got the fly wheel off and New one on both pipes smoke and sounds good . But can only get it to run on starting fluid. The petcock has good flow . But when I connect it to the fuel line it's doesn't come out much at all. Causing the carbs to be dry and not fire . Have checked the lines no blockage floats are 21mm 280 main jet 25 pilot jet. What could cause the fuel to not flow to the carbs ? Oh yes it has gas and yes the filters on petcock are clean .

i once also had a problem with petcock. when i pulled it out of the tank, i saw that the brass tubes were totally corroded and looked like a swiss cheese. that pet cock was probably the main culprit, why the pilot jet on the right sided carb always got clogged. replaced it by an brand new after-market one of good OEM quality...no problems since then!

[Fordmaster101]

It worked cleared it right up. Smoked like a mother but ohhh ya it sounds good and alive thanks for all the help 

[375hp banshees]

What did you use & how did you use it?

 

[Fordmaster101]

Seafoam . Disconnect the fuel line spayed air through.  Than poored seafoam in line till filled. Than let sit for an hr . Connected the line again ran the bike till stopped dumping smoke ,Than just repeated one more time and it did the trick.