Different question on crank

[bansheeboy91]

I'm in the process of rebuilding my engine from crank up. I've got the bottom end soitting in the case, but before I seal it up, I have a question. The crank I ordered has rubber O-Rings on both sides. On the clutch side, the half moon clip sits in the same groove as the rubber O-Ring. Do I run the O-Ring AND the half moon clip, or remove the rubber rings?

[bansheeboy91]

I'm trying to upload a picture, but my pic is bigger then 50KB.

[guns4children]

Upload to photobucket and paste img code here

[bigweav81]

Tapatalk

 

Sent from my SM-S820L using Tapatalk

[bigweav81]

What brand of crank?

 

Sent from my SM-S820L using Tapatalk

[bansheeboy91]

[bansheeboy91]

[bansheeboy91]

It's a stock crank, just an OEM replacement. As you can see, when the crank is seated, the ring gets pushed up by the half moon clip about 1/8th IN.

Edited December 18, 2016 by bansheeboy91

[trickedcarbine]

It's a stock crank, just an OEM replacement. As you can see, when the crank is seated, the ring gets pushed up by the half moon clip about 1/8th IN.

Take that O ring off all together. Just use the C clip in that groove.

[n2otoofast4u]

Those are sweet looking rods! Do they say 29L on them?

[Tedder]

My new Hot Rod crank came through with rods finished like that.

And to the OP - Take that O-ring off and run a clip in the groove.

[bansheeboy91]

Those are sweet looking rods! Do they say 29L on them?

They do. Y29L. Got it through TDR about a month ago.

[guns4children]

They do. Y29L. Got it through TDR about a month ago.

Oh no...

[sheerider11]

Aren't those oem?

Weren't the 29l/r the problem?

[sleeper06]

Most crank issues arnt even crank issues, installer error 95% of the time.