First real port job

[sleeper06]

Tricked where did you get the first cylinders looks like my hand work, never mind just saw passion

[trickedcarbine]

http://bansheehq.com/forums/index.php?/topic/98071-additional-boost-ports/page-1

[Zillaguy]

Finished intake, the dime is for size reference on the boost ports.

[bigweav81]

Decent

 

sent from yo mammy house.

[registered user]

pretty cool how the dime sticks. magic tricks FTW

 

if you dont mind my .02 im not sure those boyesens will be all that affective since theyre nearly paralell with the wall, atleast thats how they appear in the photo. heres what i believe will happen, if you had a hallway with a room at the end, and 2 open doorways near the end of the hall which connect to the big room and big fan pulling extremely fast moving air through the hall. in laymen terms i think the air will simply pass right by the doors as if they werent there. this is just what i believe will happen so dont take it the wrong way. these boyesens seem to be half decent http://bansheehq.com/forums/index.php?/topic/183954-4mil-complete-top-end-drag-ported-stock-cylinders-domes-pistons/page-1

[Zillaguy]

It's really hard to see in the picture but the inside of the intake is ground out almost like a tunnel up to the mouth of the boost port. Almost a tear drop shape before the mouth of the port

[Zillaguy]

Yeah that old copper magnet works sweet!

[special06shee]

Im just a parts changer so i dont really know what im looking at/for, but it sure looks like some clean work for sure. At least if it dont run worth ya shit, ya still know ya can make it look purdy! Nice job and good luck.

[ClaudeMachining]

Finished intake, the dime is for size reference on the boost ports.

I an Jelly.

[Bennett131]

I like it, a parts changer like myself would surely bolt it up and run it.

[lil Doobie420]

pics of exuast.

[sleeper06]

Looks good buddy, I I would like to see the boost ports rite to the intake floor .nice job tho, if u have any ? Hit me up

[nyb]

Looks good buddy, I I would like to see the boost ports rite to the intake floor .nice job tho, if u have any ? Hit me up

where are you located in ny? do you have a shop, do port work? do you know of any good dyno shops besides cj in mass?   

[sleeper06]

Long Island and yes

[Zillaguy]

Looks good buddy, I I would like to see the boost ports rite to the intake floor .nice job tho, if u have any ? Hit me up

Sleeper are you meaning the boost port starting right at the floor pretty flush to the radius? I was thinking that too, that it would act like a scoop when the air passes across/through it.. i was afraid to break through the bottom. I already had to weld up the outside around the boost ports near the rear mounting studs so i could open them up as far as i did.