psd1

I run the Uni with both oiled and an outerwear! I had the 1 inch uni vents but they were a pain. I now have a large hole on the lid and the back of the box that I covered with outerwear material that I put velcro on. It has a side benefit too! If the weather gets a little cool I can just pull off a part of the outerwear instead of rejetting!

I always let mine idle and warm up for about 2 minutes. Then ride it easily for a 1/4 mile or so and it seems to be working for me. My buddy has an 03 and he just kicks it & rips it...he has already had to put a top-end on it

Check your compression...it may be time for a rebuild. Usely it is necessary to go higher (bigger) on the main jet when it gets colder since the air is more dense.

My bet is on the 310...possibly a 320! Let us know what you end up with!

Ill bet ya a dollor to a donut that it isnt for a Banshee! Let's see the picture, cause I am a little curious! OuT

Get a compression tester and post the results. The decline in performance may be hard to notice as it usually keeps getting worse little by little. Oncy you hone or bare you will notice the difference. Do the compression test and post back!

Sorry Wiz, I know nothing about 35's. Unless your weather is changing drastically from day to day (more than 20 degrees) I wouldnt know what else would cause your probs. I hope someone else can help!

I run MORE oil than that and have never fouled a plug! I run 28:1. I would look at your jetting. How does it run? What jet's are you running???

Please let us know how much the top end rebuild cost ya!

To make it a tad louder and no rejetting is required!

I love the pro-comp/works setup I run...very smooth. The paint on the arms didnt hold up well and where the shocks mount on the lowers have to be widened so the shock will fit. Other than that it is a good set-up!

No! Everyone junks the crap airfilter before it ruins their motor! Dont be cheap on this one. Buy a good set up! Uni, K&N, twin with an adapter are all ten times better than stock.

Sweet, I finally helped someone...do I get 2 stars or something??? Glad it worked out. I thought it was strange that could happen when I hadnt even removed that drain screw. Scary how dirt can get into such small places!!

What he said! When all else fails, read the E'ffin manual or cough up $30 bucks and buy a Clymers and quit wasting everyones time!!! Kidding really!

Sell it, your frames bent...really BAD!