broke

Give Jeff from Fastoys a call Fastoys

You might need to do both, the plugs will tell you.

I'm sure you've been told a "well set up" 4 mil Cub will make that, not a T-6ed Cub.

I've got a set. $40 shipped

You'll be a welcome addition to this site.

I don't even remember my screen name from back then. I have been through a few though.

I'll guess just shy of 70. Like they said above, the pipes will kill that motor. Switch them as soon as money allows.

What the title says.

Locktight, from what? The case studs? I wouldn't see it as a problem. The cases seal pretty tightly, the Yamaha bond is just there to make it completely air tight and fill any slight gaps.

Do you let them go in, or do they need to stay outside to tend the herd? I give the mormons credit, they never have to not have sex for 5 to 7 days a month. One of them should always be ready to go. Carnies

The trouble with girls in Utah is that 10 of them usually have the same husband. MORMONS freak me out. Well, clowns and Carnies do also, but not as much as Mormons. Stan is definately who I want to be when I grow up.

Good Buyer/Bad Buyer forums or just general discussion. You made the right choice.

Good luck to you, it doesn't sound like you'll need but a little bit of luck never hurts. I can't imagine what your family has been through and the trials will give details families should never have to hear. I'm not a religious man by a long shot, but if there is a God, he would have created a place just for people like that to never forget what they have done.

I've got one, $25 shipped

It might be easier to sell the 10mil crank and just buy a 14. I don't know what kind of case mods are required to go from one to the other if any, but that might just be an easier route. free bump anyway

This thread will go far.

So I get 15% of the profits if I chip in for beer? DONE. That would require me to drink less than 1/3 of the beer. So the way I look at it is I would be getting 15% of the profits for an up front investment of 33.3% of consumable resources. I'm in.

If they go for that much up there, I may be looking into a new line of work. Is there any chance you can set up buyers for lots of ten of these at a time for a 10% cut of the profits? I will start buying them up down here and tranporting them up to you. I figure I can buy your quad down here for $3000, if I can transport ten at a time I will only be looking at about $50 for freight. There I'm at $3050 a piece, if the exhange rate gives me($6,000.00 CND = $5,167.20 USD), I'm looking at $2117.20 a piece profit. If you multiply that by ten units, I will make $21,172.00 everytime I see you, which put's your share at $2117.20. Not bad too set up buyers. Good luck with your sale and have your people call my people if you would like a joint venture to proceed at this economical juncture.

I'd go with the crank first. It will be easy to add the 4Mmil cubs later, it will not be easy to add the stroker crank to stock stroke Cub jugs. The crank won't give you the power the jugs will, but it's also only 1/3 the price. You are looking at a minimum of $1300-1500 for a complete top end.

It's a decent price depending on what's all there.

Stock I believe are impossible to do, maybe with some grinding.

Where are you located and could you send pics to [email protected]

Where are you located and could you send pics to [email protected]

I think this should be deleted from the "Bad Seller" forum.

Brooke has a nicer as than broke.