Koolguyson

Lulz

Judging by the gloss black intake...I doubt that they are ported. However, a guy from MMI should know that you should be selling those cylinders as a set for no more than 200 for the pair.

Trinity is bad to the bone and that James fellow has the sexiest man voice in the industry. Now about that discount...haha

Compression readings don't have to be the same, but a cylinder @100psi likely doesn't have enough compression to even run.

True and not true. It could be a short rod stroker, in which case it will use a standard banshee piston. BUT it will/should have a spacer plate at that point. The only real way to know is to measure the stroke. You have no idea what somebody could have put in there.

Only real way to tell is to measure the stroke. If you need help with it, I am in Arroyo.

Still needing 1 more.

I want a list of at least 100 things right now. Ready? Go! On a cereal note, they are simple to install. Wedge the center of the clip into the piston groove. Squeeze the gap end with your fingers. Press the clip "ends" in as far as you can. Then with a small pocket flat blade, just finish installing the clip. Make sure you hear it SNAP. An improperly seated clip will absolutely destroy your motor. And always cover the crankcase with a rag so you don't drop the clip inside the motor.

Thanks, I'll run it by my guy. How chunked is the dirt? If it were you, would you trust yourself going 100mph across it?

I'd settle for one...

After he gets one, I want one too. Apparently they don't float

Anywhere on your property that is paddle friendly? Also, thanks for the invite.

I have a guy that I am wanting to meet up there to do some tuning on my turbo rail, but I am not sure if there are any sand dunes/river beds over there that I may be able to open the motor up at. Can any locals help me out?

I have two left cylinders. One is 65mm and is ported for trail. The other is 64.5mm and is completely stock. Bores on both cylinders are in great shape. Both can be bolted up and ran.

Just like it says. I need three square plug stators, and possibly a round just to have as a spare. Let me know what you want for them.

May want to include your location, as I'm sure you don't want to pay to have a bike shipped.

You're about 100 high.

I am out of town until the weekend, but I am fairly certain that it is stock port. I'll check and get back to you next Monday (if you haven't found one by then). Thanks

I have a 65.5mm left cylinder. Doesn't need to be bored, and is cherry.

I ended up at the lake over the weekend. Sorry about that. I have one fat bar clamp, and one standard bar clamp. Your pick. Fat clamp is anodized black, and I believe the standard is polished.

It's a +1 stem. I'll text you some pictures tomorrow afternoon.

I have a pc'ed Roll Design steering stem with bar mounts for 200

Like it says...need a new 4mm long rod crank. Thanks

I have new ones in the box. What are you looking to spend?

Fairly certain that I have a set of works shocks. I'll look on Monday (out of town for Fathers day)