i dont know what to tell you about the straight cuts??i run straight cuts on all the bigger motors 7 and up..rememder if anything its to take the load off..
only that the tranny wasn't holding..he's pretty cool and will do anything to help you out,but billet was the way to go on that..havent had a problem since..
1-4 clutch 5&6 i think is the way to go..i had a friend that had a 10mill cub(72) that would brake trannys left and right,thats why i asked if you were going billet...get ready for all the head achs w/ a cut stocker
prices reduced!!shipped in the lower 48..after this it's going on flea bay
crank 580
cubs 650
cases 200
head 180
carbs SOLD
reeds 100
cpis(diffrent set than stated above) 400