Jump to content

Snopczynski

Members
  • Posts

    5,878
  • Joined

  • Last visited

  • Days Won

    2

Everything posted by Snopczynski

  1. I have been using the m60 with red dot and steady aim perk with double tap perk. I use the same setup on the m4 also. On tight quarters maps like shipment I use the automatic shotgun with red dot, steady aim, and fast reload perks. I also like the smoke grenades alot. Sniping is hard to do without the R700, but I have the sniper rifles setup with steady aim, and fast reload. I hit level 32 last night.
  2. It should be close to a pwk. It has a powerjet doesn't it?
  3. Once again, the needle size is important. I need to know what needle is in the bike. That is also a humongous pilot jet, and you also have to adjust the air screw for idle mixture.
  4. Some bikes sold in some states dont even have vin's cause the state may be a non-title state. Now if the frame has been chopped and stuff added, that was up to you to notice. If the bike got titled as a utah bike, chances are its either a wrecked rebuilt, a once non-titled bike that had to be registered, or its a frame up build. If the vin is clean, then dont worry about it. Its up to you though on the other stuff, you have to look it over before you pay. No one else can do that.
  5. made it to level 27 so far.
  6. I HAVE A 35MM PWK BOWL WITH A WELDED DRAIN, that should fix it. I have it up for sale also.
  7. around 185-190 main, eek and get an eej needle. start in middle clip position. 2 turns out on air screw with 45 pilot jet.
  8. Epilogue mission is just a level. There are 3 acts with like 7-10 levels per act, then there is epilogue mission. The game is not short at all. It took me about 10 hours to beat epilogue on Veteran.
  9. One adjustment at a time, start with the main jet, then needle, then pilot jet and air screw. I usually do 2 wide open runs and check the plug color. Plug chops are a waste of time and money if you know what to look for feeling wise, and color wise on the plug.
  10. Here is me playing epilogue mission in Arcade on hardened difficulty. Video Link
  11. I beat epilogue finally, so when you can go back in on arcade and play it. Play epilogue in Arcade on hardened, mucho grandes points! :biggrin:
  12. Its too lean 1/4-3/4 throttle according to the needle chart I usually use. You can try dropping the pilot jet down to like a 48 and see what it does for you. That needle your running is leaner than even a dek though. Here is a chart for you too reference. Sudco needle chart The 38mm air striker is new ground though, so anything is possible. Try squeezing the pilot down a scoche and see if there is a difference. Dont wing that thing out too much though until you know the needle is the right size.
  13. The epilogue mission is making me want to rip my face off!
  14. That needle is for a twin carb setup. you need at least an eek or an eej to start with. Sudco, cascade, carb parts wherehouse, and ironically pats small engine all sell the needles.
  15. The huge problem with everyone that asks for jetting help on these 2 into 1 setups is no one provides thew info on the needle. The needle by far is the most important part of getting one of these setups to run right. So I need to know what needle you have in it, and where your clip position is at. Off hand if you pull the choke and the bike pins, it has to be getting air from somehwhere besides the slide. Cause its got to have air and fuel to rev up like that.
  16. What type of pipe is the Bill's pipes supposed to be? Anyone know how the powerband is layed out on them?
  17. I made it to the vip 5 times last night. Fleshwounded the terrorist once and it failed me. The other 4 times I shot the vip in the head on accident.
  18. What needle do you have in it? What clip position is it in?
  19. Hold the puller flats with an adjustable wrench (resting on the footpeg) and turn the center seperation bolt with a 1/2" breaker bar. Do not hit the flywheel with anything.
  20. Which fmf pipes?
  21. If you want alot of torque, run the pro circuits. It has the most torque of any bolt on pre-made pipe. We have done some dyno testing on it recently, and I recently switched to them from a dynoport 2 into 1 pipe. It makes a lot of wheelie pulling power down low and through the midrange.
  22. my fingers hurt!
  23. So I won the war on veteran and then there is a bonus hidden map you get. So right now I have to rescue the vip on a 2 story plane with about 8,000 bad guys that come from everywhere. Im addicted to this game. This guy did it, I wish I could. COD4 Epilogue Mission on Veteran Link
×
×
  • Create New...