shanYE west

1/2"

The craftsman ratchets I had are 72 tooth and they are available with longer handles. nice pieces actually.

got a harbor freight universal.. it snaped with about 3lbs of torque..

why are you wanting to run blaster pistons? depending on your cylinders. blasters pistons are not possible. Also.. you'll need more then just milling the head to work with a blaster piston.

Selling a billet axle nut. Anodized blue. In good shape other then the adjuster holes are wollared out a bit. $25 shipped.

only saying that just because its made in taiwan.. dont mean its garbage.

they claimed that they increase velocity for better throttle response.. but.. ended up only being good to lift the carbs off the actuator arm.

everyone wants to sell them... can't be that bad i guess.. lol 15 shipped?

blue-point ratchet wrenches are amazing.. bought off snap on truck.. made in taiwan

I'm no fan of wiseco either.. I only use them in my big motor because i'm forced too.. Actually.. it probably was wiseco's fault since they get them in bulk.. Its their job to check the parts before packaging. Also.. wiseco is very helpful on the phone and would have sent you a new pin. find it funny you bought another wang crank after all your rants about taiwan.

If anyone has one of these 29l/r 4mil cranks that their scared to use.. I'll take it.

Umm.. I know them were crank numbers.. Hence my comment. And NO ONE posts crank numbers for their banshee's.. hell.. my banshee probably is near 300hp at the crank! ok...

I really dont know.. lol I was actually done with this thread.. I'm done again.

them are crank #'s... All of yamaha's stated number are based off crank dyno.

ahh.. gotcha.. similar to your "outta this ballpark" hp numbers you were posting about sleds.. I understand. your problem is your throwing all taiwan rods under the bus.. not ALL taiwan rods are shit.

I really can't believe it took you guys that long to notice that.. my point was... 90% of all big hp banshee's use taiwan rods with very minimal rod failure.

^^^ This ^^^

you can log a lot of miles with a modded motor.. I'd get 2-3 hours in the trails with my dune build and still have fuel left. The bike wasn't very fun to ride in the woods though. Trails and drag racing are on opposite ends of the spectrum.. So you need to pick which side you want to be on. Trails----------------^---------------Drag

wouldn't put them on my drag bike.. Not a fan.... To each their own.

who ported it??

most hardware shops around here carry PVC tubing.. but not the tygon formulated. the genereic tubing gets brittle after a bit..

shit... labor day.. lol

I'm going to see if I can get a site there for memorial weekend.

Tygon is the best stuff. stays pliable. you can get it from mcmasters