Alex! Posted May 11, 2007 Report Posted May 11, 2007 What is everyone gapping their rings at? does 0.014 +- 0.002 soud good? Quote
majicmike Posted May 11, 2007 Report Posted May 11, 2007 What is everyone gapping their rings at? does 0.014 +- 0.002 soud good? thats a bit loose for me I like .012 + - .002 but I take my time and get it right on. That ring end gap is very critical with the cubs Quote
Alex! Posted May 11, 2007 Author Report Posted May 11, 2007 it's the factory cylinders (ported of course!) Quote
majicmike Posted May 11, 2007 Report Posted May 11, 2007 same thing I was just putting extra info out for others that may Have the same question. I would shoot for .012 on stock cylinders as well :thumbsup: Quote
Bansh-eman Posted May 11, 2007 Report Posted May 11, 2007 on stock bore... wiesco prolites.. call for .010 to .012... i set mine at .011 Quote
chronicwatson Posted May 11, 2007 Report Posted May 11, 2007 where did you get your cylinders ported? Quote
Matt96shee Posted May 11, 2007 Report Posted May 11, 2007 are you guys filing these by hand? could you maybe highlight your process? i ask because i'm heading to the shop to pic up my rings in a few minutes. thanks, matt thats a bit loose for me I like .012 + - .002 but I take my time and get it right on. That ring end gap is very critical with the cubs Quote
majicmike Posted May 11, 2007 Report Posted May 11, 2007 IMO there is only one way with the right tool http://store.summitracing.com/egnsearch.as...p;y=11&x=27 this makes sure you take equal amonts off both sides of the ring :thumbsup: Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.