New setup way off.

[brock42]

Will do thanks again. 

[brock42]

What other holes should I run wire through other than the  actual pilot hole itself. 

[locogato11283]

20 minutes ago, brock42 said:

What other holes should I run wire through other than the  actual pilot hole itself. 

Just the pilots. You should be able to clearly see up through the mains, so check those too.

[brock42]

ok both carbs are clear. Will update shortly. 

[brock42]

No change still best when needle is almost closed. 

[Ayesully810]

How hot is it where u are at? u should just keep the pods on unless ur riding in wet crap all the time.  imo i think a stock pilot will do with just pods and pipes as long as its not really cold where your at

Edited January 15, 2018 by Ayesully810

[brock42]

Temp varies I'm in Alabama so it'll be 30s one day and 60 the next. It's. It's starving for fuel at idle and I can't figure why. 

[Ayesully810]

44 minutes ago, brock42 said:

No change still best when needle is almost closed. 

What does this mean? What are u adjusting? 

If it swings that much I would run a 27.5 pilot and try it with 2 turns out on your air / fuel screw and turn it in if it needs more fuel. is your choke tube hooked up?

Edited January 15, 2018 by Ayesully810

[registered user]

start it with choke on and leave it on. wack throttle a few times and see if boggs gone which im thinking it will be. then u know the problem

[brock42]

I'm running 27.5 pilots now and at 2 turns out it has a bogg off idle and as I screw the needle in to richen mixture the bog gets better. But I'm all the way in on my air screw.  Choke tube is hooked up on the nipples that's basically in line with the choke plunger. 

[registered user]

every instance ive encountered , bog meens its leen. i just told u how to see if its your prob in less than 5min

[Ayesully810]

if its clearing up then try a 30 at half a turn out and adjust from there. are u sure the motor is completely stock? 

[brock42]

I was told it was completely stock.  I had to replace a base gasket and noticed it looked as if it may have had some kind of porting work done. And when the choke is pulled it does rev better. But when I install 30 pilots it acts the same way. It's almost as if it needs a bigger pilot but from what I've got it should t need anymore. 

Edited January 15, 2018 by brock42

[Ayesully810]

If its ported than might explain ur issue

Sent from my LGMS210 using Tapatalk

[brock42]

I just reinstalled the 30 pilots and was able to get the off idle bog gone at about a half turn out on the air screw. Is it common to need anything bigger that a 30 pilot.