steering issue

[maggdog]

when i've ride on stock a arms everything was good, ball joint arms tight, tie ends tight, run low and high speeds not play not uncontrol

 

i put +2 +1 arms, not play on steering when i slow riding all is normal but when run on high speed the steering turn more sensitive, more high speed more more decontrol

 

has stock shocks, 19" tire on front 20" rear, is the same setup on tire before and after put the +2 +1 and never issue on high speeds on stock arms

 

whats the problem? bad adjust on a arm tie rods?

 

all are tight, the problem is when change the speed, i can't run on top speed

[hercalmighty]

What arms are you running? Are they adjustable? If so, how did you set it up?

 

Sent from my VS990 using Tapatalk

[Larry's Shee]

Toe in set ?? Caster and camber good ??

Edited May 27, 2016 by Larry's Shee

[trickedcarbine]

Time for an alignment. You are probably a little off on the toe adjustment. That makes it feel a bit darty at speed.

[Motooutcastxxx]

If you happen to be running the Alba arms, did you put the metal spacers/washers in the correct spots? They're supposed to affect exactly what you're describing, and according to their directions depending on where you put them determines steering sensitivity.

[bigweav81]

This is true.

 

Sent from my SM-S820L using Tapatalk

[hoppedupandcutdown]

you need more positive caster.

Then check the toe in