BlksnshN Posted July 10, 2013 Report Posted July 10, 2013 With the lack of any shops with a Dyno anywhere in my area I'm left wondering what kind of HP my Banshee is making. I just picked it up a couple weeks ago and haven't even torn the carbs down to check the jetting but it seems spot on, pulls through every gear all the way to the top of sixth without a stumble. My mods are as follows. 4 mil crank 65mm bore stock cylinders with no port work +4 timing CPI inframe pipes K&N pods VF3 reeds Shaved stock head (not sure how much was shaved) My seat dyno says somewhere between 50 - 55. Anyone have a similar setup that they've had on a dyno? I just ordered a Chariot head and once I decide on a builder I'm going to send my cylinders out to have a dune port done as well as have some custom domes cut for as much compression as I can run on pump gas. And maybe a second set for 110 race fuel. Then, when funds allow for it, I want to pick up a larger set of carbs. Any recommendations? Hoping to make 70+ HP when it's all said and done. Quote
Larry's Shee Posted July 10, 2013 Report Posted July 10, 2013 head spacer or base spacer or is head cut for 4mil? Quote
BlksnshN Posted July 10, 2013 Author Report Posted July 10, 2013 head spacer or base spacer or is head cut for 4mil? It appears that there is a base spacer in there. [/url]">http:// Quote
BlksnshN Posted July 10, 2013 Author Report Posted July 10, 2013 17 How about after I put those new A Arms on? Over 9000? Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.