help w this port work

[tsharktim]

I picked up a set of cylinders real cheap n found that they were ported. I have no idea to tell what type of port this is or if bad port job. Any help would be great. Sure. I could just put em on and see but I can't ride where I'm at and its over 2 hrs away. Thanks

[Rustynail]

Looks home ported to me

[Finch]

take a pic of the bottom transfers and the exh port i wanna see what they look like lol.

[tsharktim]

I'm tryin to resize them right now.

[Nightmare]

Home port X2

 

Sent from my SGH-T679 using Tapatalk 2

[tsharktim]

Here ya go....heckle away....

[HolySheet]

That is one well thought out and clean port jobs...

[Finch]

looks alot better then the intakes! ive seen some pretty ugly portwork run good tho cant always judge a book by its cover

[tsharktim]

Yeah....guess I might have to see how the run before I say too much. Anyway to tell what type they'd be close to?

[Starwriter]

Looks like a Billy Bob homebrew "clean up" port. It doesn't look like they even touched the tops of the transfers. Send them to a builder and get a real port job done.

[Nieskes]

Better then I could do, try them out and see how it works.

[tsharktim]

I just figured Id see what everyone else thought about them. Thanks for the input if I decide to run them as they are Ill post results.

[possum]

Ive seen some builders dune ports with less work then this. So these arent that bad, or that good either.

[Pasi S.]

Measure from the deck to a roof of exhaust port. If it is rised alot and those transfers are stock duration, it might have good pull up top, but not much bottom end power.

[trickedcarbine]

The work is definitely just some Joe in his own garage. Although not pretty its not bad. Looks like he just tried to clean a few things up and knife edge the intakes and transfer tunnels. Good news, they aren't to far gone at all. You can definitely have a builder re work them if ever needed.