yfz 450 pegs?

[Thack82]

I'm posting this for future Banshee Owner's looking for information on this topic and wanting to upgrade the OEM Banshee Foot Peg's using the Stock YFZ-450R/X Race Peg's.

 

Answer: Yes, the 2009+ YFZR-450R/X Pegs will fit the Banshee with very minimal modification. You need to cut or grind a spacer off the back of the peg on the PTO (Clutch) slide. Then you need to take a small carbide bit and slot all four holes 3mm on the YFZR/X Peg's and that's it...... Other than one fine thread foot peg bolt that is a little longer.

 

I pasted a tool list thats required to complete the foot peg swap successfully bellow:

 

- Take Off YFZ-450R/X Racing Foot Pegs.

- Four Inch Grinder w/ 80g Sanding Wheel.

- One Longer Foot Peg Bolt For Right Side Peg.

- Pneumatic Die Grinder w/ Small Carbide Porting Bit.

- 15mm Open Box End Wrench

- Can Of Brake Cleaner & Anti-Sieze for the foot peg mounting hardware.

 

[monster]

 

IMS Rapper 660 pegs bolted on with just a spacer on right side and had to cut shifter pivot off left side.

 

 

 

Sent from my iPhone using Tapatalk

[Strm Trpr]

I've been rockin those for quite a while.

Zero modification needed to shifter side and only a 12mm long spacer with a 1/2" hole and a 12mm longer screw on brake side.

 

 

[Deadbeat]

neat

[ClaudeMachining]

Good job!

[mailman]

Bump for a good topic.  I just put the '09 YFZ pegs on my Shee.  They are so much nicer than the stock pegs.