locogato11283

I acquired these pipes a couple years ago thinking I may end up building something to use them on. At this point I seriously doubt I ever run them on anything. These pipes are in the original shipping box from Tom Borrink dated October 2005. It appears they were mounted but don't appear to have been run any if at all. They are as close to mint as you will ever see out of original Rockets. They can be used on a wide variety of motors and will perform very well. I ran a different set I had on 4mm stock cylinder motors all the way up to my 10mm Cub. Included are o-ringed billet clamps for the silencers. $700 includes shipping and PayPal fees. I will now entertain reasonable offers. I don't need any other pipes, parts or stuff to trade. Money is the only trade I will consider.

I don't disagree. I am going to try to get a hold of Jim again.

I only run Klotz in the DMs.

There are tons of stories about Sidewinder not standing by their warranty on the internet. I run PBI fronts and Primary Drive rears on our 18DMs and they hold up well. When they start to wear I toss them. They're cheap enough that they can be replaced regularly.

It's his power animal.

I see a lot of 100+ MPH 400EX on Craigslist too.

I'm not that open about it.

That site is owned by the only openly gay drag racer.

I thought we were talking about just on BansheeHQ?

What do you mean by wrong master link?

I would say HOD Chassis has the fastest here.. I think his old triple went 3.2xxx in 300'.

I would be checking on alignment issues. What about the chain? Is it old?

Ripping teeth of aluminum or steel rears?

Paint sucks. PC it for maximum durability.

I was kidding.

How much for the clutch parts?

Cam's shop is in his front yard. Jeff would be out though. His shop is in his back yard.

I'd probably pull the wheel and hub off and check the spindle. I don't see anything there that looks messed up. If the spindle is bent upwards it would cause the wheel to lean in like that.

He's right.. Over time, aluminum forms a thin coat of aluminum oxide on its exterior, which melts at a much higher temperature than aluminum. So, before welding any piece of aluminum (even a brand new piece), you have to clean away the aluminum oxide.

Can you take a pic of the whole front end? I mean, both sides in one pic.

14 paddle stag extremes. 9x9 wheels drag cut. 77" rollout @ 5 psi. Like new. $600 shipped in US. I'm just posting these for Redline Racing! Direct calls or PMs to Cam!

You might give then a call. With everything they have I can't imagine they wouldn't have those too.

I was agreeing with you by being sarcastic..

Why? It was obviously the customer's fault for expecting it done when you said it would be done.

Are you really this stupid? Customer calls builder X on September 1 and asks if builder X can have a set of cylinders done by September 15. Builder X says yes. Time comes and builder X doesn't have them done. Customer's fault?