slobanshee

Not all over rides require springs though do they?

I don't know enough about the workings of the override drums and stuff. But I have had the drum out looking for unusual wear or anything that may shed some light on it. This trans is one without the springs betwen the forks. Been thinking of adding them to see if it has any affect

Think that'd affect it for this? I'm at a loss. Trans works great other wise

Picked a bike up with 1-5 n down over ride. Not sure who cut it. Ive have had it apart looking over stuff a few times . Anyway. When you try to roll it backward. Like off your trailer it'll randomly lock up. Pull it forward and itll roll back a bit. Then lock up again. Sometimes it'll roll fine. Sometimes it won't roll 2ft. I'm baffled. Good forks, eccentric screw. Shifts and works great. But is a pain in the ass. Gets old fighting rolling it off the trailer.... Any advise?

Hmm stinky could use this

I use Corey's harnesses also. One I got had me chasing all the stuff you are. Wound up being one of the connectors for the cdi. When I plugged it in the pin slid up and didn't make good contact. Couldn't tell by looking cause how plugs made He sent me parrs to fix it free too.

I have a 421 serval from Jeff. Light clean up casting port. True pump gas, Shearers and 35pwks. 83hp. Guy to far from me made more than me with his fast 421 serval also

Finally got a chance to ride it today. Swapped to shearer inframes. Here's the chops with 340s. Was thinkn of going up. Thoughts?

The state park itself allows you to reserve some nice spots south of south gate now. They concreted them. Other wise it hasn't changed a whole lot.

I havnt found any 35s either. Guess noones selling

Wanna sell the trans out of it?

Check for spark. Make sure slides arnt backward

Looking for a rear 13.5in ish shaw!

Thanks. I'll see what I can find

Looking for some sb sf in frame shearers. Lmk!!! Thanks!

How much on black slider

Been wanting to do one of the midnight drag racing events they put on during the summer

Have you seen any posts or comparisons of performance on smaller than dm builds? Like your 10cheetah or even 4-10mil Cubs?

Sold*

Money sent for forks. Thanks!!

We have 12-14 paddle rippers for little Sahara. Rippers work well there. We don't race far enough usually to feel the big end slowing down. Maybe a bit much for your bike though

Cool. Thanks guys

Getting close to finishing up my 421 serval built from extra parts I had laying around....so kinda a collection of crap. Ha. Wanted to get a good starting point on jetting. 4 mil serval with F.A.S.T. cleanup, 24cc domes, 145ish psi, vf3 reeds, stock carbs, pod filters, and T5s at 900ish feet above sea level. Was thinking somewhere along the lines of 30 pilot and 340 main maybe? Thanks!!!

He doesn't, a buddy bought it. He may wanna sell it though

Got two 4 mill Cubs at 900ft above sea level. .122 mains/dumps. 60 pilots. EGL needle in middle. Does well for 300ft sand drags