Smokestack

Idle screw

If your reeds dont have a good seal the motor wont pull the fuel into the cylinders very well. Same for most air leaks from what i have heard.

I would pull the petcock and clean the screen in it. Then pull the jets out of your carbs and make sure of the size and clean them really good. Pull your air screw out and clean it really good too.

I have the same issue but i tore mine down for a winter project. Just putting it back together again now. Installed a timing plate and when tryin to take the flywheel off i inserted a screw driver into one of the holes in the flywheel So i bent one of the white things on the lower half of the stator.... So needless to say i think that is my issue.

2500...thats insane. I gotta win the lottery before this whole banshee addiction sets in

Only trouble i had with that issue was bad reeds. But your at the right place

+1 or maybe 2

I would say up the mains and check the gap on the flywheel. But im a newb and the pros are at work

How tuff is that subframe mod? I like how its like the newer quads. Then when i get nuts with a wheelie i can just get a new subframe.. Although for like 8 times the cost of the newer quads Yeah i guess i need to rethink this

Thanks guys. Even the things i thought would be easy are a pain

Tryin to install my timing plate and cannot get the flywheel to budge. Yes i have the bolt off and the right tool. My question is should i leave it under pressure with the puller? Would that hurt anything? I have read and read and tried tapping the bolt and everything. Nothing is working so i soaked it down again with oil. So should i just keep doing that or keep the remover tight as well?

On the back of my block i found engraved a 9N..34 on the top and 314...74 on the bottom. Does this mean anything? Its been engraved by someone. I didnt know what it would or could mean

Yes the housing from what i have read. Its much better. Alot easier to adjust the chain. No more hassle from crooked rear axle.... I want one. Just dont have the cash right now lol. I have heard the bearings last alot longer too. I guess from being true all the time?

Im gonna try the Klotz as well. ATF didnt work too well for me either. Thanks for the info

Im just chillin here and after reading kinda wonder if there was any oil in that gas And stop fighting tuff guys

I hope. Mine is a rolling chassis now :rotflmao:Tearing into the motor today. Hope we can all meet up again and i will have my shee too

That is one sick lookin engine. Man O man..

Thats bad. I love that vid

Nice one So thats what a good port job will do Gotta start saving up again so you can do mine

I remember what you mean. I thought he just took off then kinda stopped. Mighta been a shift. I remember your faces but cant remember what everyone was riding lol.

I wanted to film alot more but had issues with my front rim. And it was tuff to ride and keep the cam from falling outta my pocket . In case anyone wanted to know what was up with me i have a bad back. So riding bikes is a major pain for me. Literally lol. I could only ride for a little while and then park..... But i still had a blast watchin you all ride and checkin out the cool shees

Nothing. The one shee took off before the rest and i turned when i seen the others sitting there Told ya i sucked with the camera. I layed my bike on the sand hill and was going to walk over more but another quad shot around it and almost ran me over. Thats why i stayed at the top with my bike

Yeah i thought so too. But some guys were across the street and in different areas. At least i thought they were all with us

I didnt get much and im not good with a camera I didnt have anywhere to put my bike so i could get closer when everyone was racing so it all sucks