lowbuckracing

Location?

Call Kevin,he can tell you the best setup for his port job..I'm pretty sure the dual carbs on a ported motor will rip the 2 into 1 setup apart when it is done right.

How much for the complete harness shipped to california,post up pics if possible,I know a guy looking for one.

Check to see if the woodruff key is worn out or missing..

Price on pipe hangers..

Send text and pic again,didn't receive anything...

Can u text me a pic? 951-897-9528, what watt bulb and how much shipped to 92223 cali...

Looking for bright lights...

Billet gas cap for a banshee?

Take 400 shipped? Send money Friday via money gram..lmk 951-897-9528 JB.

What happend on the auction?

What kind of axle is that? Length,mm,any hubs or hardware for it? cost shipped to 92223 if its for banshee..

Pm sent..

You can have Tim from stellar build you some +2+1 for the banshee and already has the geometry set up for yfz 450 shock,just request it.

For what weight was it sprung?

Pm me a price for both carb pipes and shipped to 92333

What kind of top end are you putting on that's a 500 cc combo? If your gonna build a drag bike or hill shooter you will not be dune ridding to much in the dunes.If you want a dune bike just port your stock cylinders ,throw on some 35 carb and a plus 4 swinger and your good to go.I've built many dune bikes and a few hillshooters and theres a big difference in both.what type of ridding do you enjoy most?

The kit comes with step by step instructions...

Pull the spark plug on that side and smell for coolant.get a flashlight to see if there is any in the cylinder.sounds like a bad head gasket.is it a stock or cooled?

Check all wires going to your coil,make sure they didn't come loose.May wanna see if your pick up for the flywheel has a loose screw..

It's always nice when they start first or second kick.if it looks good ,sounds good and and rips with no hesitation then its probably good.Is this your first banshee? If you have a compression tester take it with you and check both cylinders,ask what ratio he mixes oil,how often did he do oil change,new top end or been a while.any oil leaks,water leaks,clutch slip when you take off.good luck and throw up some pics.

Does it run? Have registration or pink on it? Pics...trades?Is that price shipped or pic up only?

I'm interested,why are you selling them? What kind of ridding do you do and how much do you weigh?

Metric sockets 8 mm to 17, a few metric wrenches,needle nose pliers, a hammer and punch, air tools are great for tearing down,make sure all your ground spots are really clean on your new frame,use a penetrating oil on all your nuts and bolts the day before a tear down,pressure wash if possible.It's always nicer to work on a cleaner bike.use a good degreaser to..its always a good time to flush out your radiator and replace any bad fuel lines or old motor and pipe mounts.good luck and take some pics as you go..don't forget you will also need a set of new cotter pins for everything.