Leaderboard

Finally getting started on my 03 build. Right now I'm just getting things mocked up before I go after the chassis. Going to add some support to the steering stem hoop, stem stop area, and possibly a few other spots on the chassis. Redline is building a 421 serval for me so while that's out I can hopefully get the chassis done and coated. Build is for trails and play mainly. Running Fireball +2 swing arm and +2 +1 EGC front arms from Fireball as well. Going to ride on fox floats all the way around, hoping the rear gets here soon, been waiting over a month for it. Anyway, here are some pics of the progress so far. I know it's not much but it's a start. Sent from my SM-G930R4 using Tapatalk

Hoping for it to be done in a few months. Had some setbacks but its in the right hands now.

My shee has been all over the stock cylinder, stock stroke spectrum. with basic bolt ons from sea level to about 1000 feet mixing 32:1 280 mains ran the best with the FMF pipes. it ran ok up to 310 main, but ALWAYS ran best with a 27.5 pilot. toomey needle liked 1 notch closer to the tip and the stock needle liked the center notch. Start with the 300 main and do a plug chop. start fat it doesn't hurt....

Looks good

15 minutes with that jetting could have hurt the engine. When I had 2 bikes with FMFs, the jetting was 280 or 290 main, 27.5 pilot, clip in the middle of the stock needle. when jetting, you should always start rich and work towards lean- start with a big number and go smaller 1 size at a time.

mix ratio can have an effect on jetting too......

Take it off, put banshee shit on.

Just because you afro rigged shit together, doesn't mean you made them work. YFZ450 a-arms will not work on a banshee frame. Stop being a dumbass and run the correct parts.

Finally!!! Envoyé de mon SM-G935W8 en utilisant Tapatalk