lonestar Posted May 29, 2008 Report Posted May 29, 2008 Check out jjandaracing.com makes these niffty hex idle screws. For Keihin carbs. NICE just got a set no more screw drivers or your fingers. 8mm wrench all that is needed. I may even drill a hole on one of the flat spot put a drif pin make like a T-handle. This guy is the same guy that makes the billet drag axles. Go to his web site look under (other stuff) they ain't cheap. Well worth it IMO. Check it out Quote
jbooker82 Posted May 30, 2008 Report Posted May 30, 2008 Or you can get a metal Idle Screw from Fast for 5 bucks. http://www.farmandsandtoys.com/partdetail.asp?partid=119 Quote
lonestar Posted May 30, 2008 Author Report Posted May 30, 2008 (edited) I got them from jeff brass idle screws. You still got to use a screw driver. Can't use screw driver on the clutch side carb no room have to use your fingers. (ITS A BITCH) The Hex ones that jj sells you use 8mm open-end wrench Edited May 30, 2008 by lonestar Quote
BellicoseBanshee Posted May 30, 2008 Report Posted May 30, 2008 Those idle screws are very nice, but a little expensive. I might have to get some though, the plastics ones are a joke. :cool: Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.