is this worth it

[samc]

http://www.vitosperformance.com/atv_parts/...=176&page=1

 

this worth the 60 bucks or should i just disconnect the tors and buy a new throttle cable

[XxMeltIcexX]

http://www.vitosperformance.com/atv_parts/...=176&page=1

 

this worth the 60 bucks or should i just disconnect the tors and buy a new throttle cable

 

You need the eliminator kit

[samc]

thanks dude, should i just pay to have a shop drill the carbs? idk i dont wanna mess up on somethinggg.

[jayzx10r]

thanks dude, should i just pay to have a shop drill the carbs? idk i dont wanna mess up on somethinggg.

If you can drill a hole, you can do this. Just wad rags in all 3 openings and have at it!!

You get bonus points for using compressed air to blow out any small fragments that may have gotten by the rags.... :thumbsup:

[doorslammer]

If you can drill a hole, you can do this. Just wad rags in all 3 openings and have at it!!

You get bonus points for using compressed air to blow out any small fragments that may have gotten by the rags.... :thumbsup:

 

YESSSS!!! bonus points

[RagunCajun]

I would say get it. It cleans up the underneath meanwhile getting rid of possible problems in the future. I used the motion pro kit. It had very shitty instructions. Perhaps the vito's one is better.

 

As for the drilling of the holes, it's very simple. There's MANY threads on this and you can read a lot of tips on how to do it.

[samc]

thanks guys i just baught the motion pro one off RM ATV with 2 days shipping for $66 bucks. now i gotta wait till next payday to get something else for the shee.

[zach45]

no get it from toomey

[samc]

too late.

=/ oh well it came with $9 dollar 2 day shipping.

3 day was $13 bucks lol

[BellicoseBanshee]

too late.

=/ oh well it came with $9 dollar 2 day shipping.

3 day was $13 bucks lol

I would not worry about it, all three (RMATV, Toomey, and Vito's) kits look like they have the same caps, adjustment screws, cable, and idle screws. The Toomey kit I have looks exactly the same as the Motion Pro. As long as the tap is a 6mm X 0.75 and the drill bit is a #6, you will be fine (and I am sure it is).

 

I do not know, but I would not be surprised if Motion Pro supplies Toomey and Vito's with the caps, adjustment screws, idle screws, and the cable. So, you will be just fine with the one you ordered..... :cool: