twinrock Posted May 9, 2007 Report Posted May 9, 2007 if im to run a stroked crank of 4mm..will simply using a bace plate re aline all the ports and stuff..or will port timming still be an issue..? i know that pple are not a fan of the bace plate as it creates one more place to posibly leak..but if i did it i would seem weld it on to the barrels ..thanks.. Quote
blowit Posted May 9, 2007 Report Posted May 9, 2007 if im to run a stroked crank of 4mm..will simply using a bace plate re aline all the ports and stuff..or will port timming still be an issue..? i know that pple are not a fan of the bace plate as it creates one more place to posibly leak..but if i did it i would seem weld it on to the barrels ..thanks.. We do not recommend them because of port timing problems. Custom head work is preferred for optimum performance. We offer stock head mods or NOSS builds the custom domes for the stroker. Brandon Quote
locogato11283 Posted May 9, 2007 Report Posted May 9, 2007 id stay away from spacer plates. do it right and have your cylinders ported correctly and get the proper domes and and aftermarket head to accept the stroke. not saying it cant be done with the plate, but it would be better to do it the other way. Quote
jbooker82 Posted May 9, 2007 Report Posted May 9, 2007 You put that 2mm plate under the cylinders your going to advance all the port timings by 2mm's. I would just run a cut head instead. Quote
twinrock Posted May 9, 2007 Author Report Posted May 9, 2007 You put that 2mm plate under the cylinders your going to advance all the port timings by 2mm's. I would just run a cut head instead. ok thanks...so if i cut the domes..what about all the other transfee and exaust ports,,will they need to be altered? Quote
dajogejr Posted May 9, 2007 Report Posted May 9, 2007 ok thanks...so if i cut the domes..what about all the other transfee and exaust ports,,will they need to be altered? Yes...exactly. It should still run without the porting changed...it just won't run as well as it should... Quote
jbooker82 Posted May 9, 2007 Report Posted May 9, 2007 ok thanks...so if i cut the domes..what about all the other transfee and exaust ports,,will they need to be altered? If your jugs are ported now then I would just run the cut domes and not try to alter the ports. I would say it is better to have the port timing on the concervitave side. Rather than go over the edge with the plate. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.