new directdrive lockout and cover but brake lever is hitting

[DUB]

When I tore my bike down I bought alot of new stuff, a new lockout clutch from direct drive being one of my mods. Now im not sure if it said anything in the installation instructions but as you can tell in the pic my brake lever is hitting the clutch cover. Any ideas??

[bansheeseat$$]

All you have to do is adjust the rod on your master cylinder so it will clear your cover.Also you may have to shim out or trim your footpeg too.

[BigRed350x]

That or heat it up with a torch and tweak it over a little bit. That's probably what I would do if shims weren't enough. It doesn't take much to bend one of those if you have a torch. Put a nice little s-shape in the lever right back by the pivot point and you would be good to go.

 

Nice blingy cover BTW.

[FireHead]

That or heat it up with a torch and tweak it over a little bit. That's probably what I would do if shims weren't enough. It doesn't take much to bend one of those if you have a torch. Put a nice little s-shape in the lever right back by the pivot point and you would be good to go.

 

Nice blingy cover BTW.

 

This is what I did when I got my DD cover. :baseball_mitt:

[locogato11283]

bend that bitch.