cdwood37 Posted July 1, 2006 Report Posted July 1, 2006 the bolts/screws that hold the springs in, how tight do i get them, do i tighten them all the way up until they bottom out on the stub that sticks up from the inner clutch hub or what? I mean do i tighten them until they don't go anymore? Quote
DIRTMAN350 Posted July 1, 2006 Report Posted July 1, 2006 Do you have a clymers manual handy? If not i think they torque down to a inch pound reading It's been a while since i did my clutch. I'm sure someone can chime in and give ya the correct torque. Quote
bansheeseat$$ Posted July 1, 2006 Report Posted July 1, 2006 the bolts/screws that hold the springs in, how tight do i get them, do i tighten them all the way up until they bottom out on the stub that sticks up from the inner clutch hub or what? I mean do i tighten them until they don't go anymore? tightening torque is 10n.m or 7.4 ft.-lb. Quote
odaen Posted July 1, 2006 Report Posted July 1, 2006 tightening torque is 10n.m or 7.4 ft.-lb. definitely don't overtorque those bolts. they break very easily. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.