beatmiester Posted July 14, 2005 Report Posted July 14, 2005 ok i got my pipes back from being rechromed they do look nice and i'm ready to go i got a K&n with a plate so now i will go with no air box lid FMF Fatty and power core silincers K&N w/outerware no lid stock carbs w/tors stock jetting also stock reeds and intake i'm in connecticut and i'm looking at running it from 65-95 degrees were do i start with the mains and pilots? thanks for the help Quote
kw04 Posted July 14, 2005 Report Posted July 14, 2005 try starting out around a 300 main and stock pilot Quote
Banshee~ Posted July 14, 2005 Report Posted July 14, 2005 try starting out around a 300 main and stock pilot 392518[/snapback] sounds good, might even try a 310 mains and 27.5 pilots. Quote
reded Posted July 14, 2005 Report Posted July 14, 2005 300 mains, clip on bottom notch, stock or 27.5 pilot Quote
350Xhilaration Posted July 15, 2005 Report Posted July 15, 2005 I just went through this over the last few days. I have a stock 2000 banshee, with TORS, Stock carbs and emgine, FMF gnarlys with Turbine core II spark arrestors, and a twin air filter. I put 260 mains in it and left everything else alone. With the lid and snorkel on, it was too rich. I pulled the lid and it runs like it should. I would say that I'm close but not perfect since I needed to pull the lid and snorkel. I'm at 2140 feet in western PA. it was about 75-78 degrees yesterday when I ran it. I am by no means an expert on this and you might seriously want to consider what the other guys on here say. I'm just sharing my experience with a similar situation. Hope you get it tuned soon. Mine really came alive after jetting it "properly" (still need to tweak it a bit) Quote
watkins Posted July 15, 2005 Report Posted July 15, 2005 Everyones bike is different but I am at sea level and 310 mains produced a nice plug chop for me. I kept the pilot the same and currently have stock clip position, but its running a little lean in the mid range so Im going to go down another notch. Just slap in some mains.. ride it and tinker with it. when you finally think you have it right do a plug chop. Quote
beatmiester Posted July 31, 2005 Author Report Posted July 31, 2005 any other ideas? 310 or 300 ? or 320? Quote
Banshee~ Posted July 31, 2005 Report Posted July 31, 2005 any other ideas? 310 or 300 ? or 320? 399353[/snapback] Your going to need to jet higher for colder weather, so 320 mains, stock or 27.5 pilot. Also you may have to play with the needle position. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.