caleb90 Posted December 1, 2020 Report Share Posted December 1, 2020 so im doing a build, getting ready to weld gusstes to the frame. now ive messured every way possible with out putting a robot romer arm on it. and best i can come up with depending where and how i measure. is the frame is between 1/16th to 1/4in square from front to rear sub frame.. normal or no? i dont want to dumo money in a twisted frame Quote Link to comment Share on other sites More sharing options...
locogato11283 Posted December 2, 2020 Report Share Posted December 2, 2020 Got any pictures? Quote Link to comment Share on other sites More sharing options...
caleb90 Posted December 2, 2020 Author Report Share Posted December 2, 2020 will get some tonight Quote Link to comment Share on other sites More sharing options...
caleb90 Posted December 4, 2020 Author Report Share Posted December 4, 2020 here ya goSent from my SM-G920V using Tapatalk Quote Link to comment Share on other sites More sharing options...
caleb90 Posted December 4, 2020 Author Report Share Posted December 4, 2020 these two measurments are from the wire bracket below steering hoop.Sent from my SM-G920V using Tapatalk Quote Link to comment Share on other sites More sharing options...
locogato11283 Posted December 4, 2020 Report Share Posted December 4, 2020 Run it. Quote Link to comment Share on other sites More sharing options...
SKEETER Posted December 4, 2020 Report Share Posted December 4, 2020 Being straight is overrated. Look at 375hp Quote Link to comment Share on other sites More sharing options...
n2otoofast4u Posted December 4, 2020 Report Share Posted December 4, 2020 WELL within Yamaha spec! Id be most concerned with Center of axle, to center of ball joints Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.