Chrome swingarm

[97Screamer]

15 minutes ago, budnelson15 said:

What is make it right? It was a $150 arm and $40 to ship.. want me to order you a new arm to replace it..

 

 

Don't know why you're mad at me but if you want to order me a new arm I'll take it. I never said you hid any damage in the pictures, I didn't look that close as the arm was already sold and now the Facebook listing is deleted. I assumed the repair could be seen in the pictures because I do recall the link went to a couple pictures that were much larger. In regards to the length,  I've measured stock arms very recently to order a new stock length and +2 for my bikes. A stock arm is ~18.75" center to center. Best I can tell from pictures yours is a -3 to -3.5". Like I said, maybe you didn't know which is why I suggested he contact you. I don't know either one of you and don't have a dog in the fight.

[kawa110]

No dog fight.

Just figuring out what i got

 

[budnelson15]

9 hours ago, 97Screamer said:

Don't know why you're mad at me but if you want to order me a new arm I'll take it. I never said you hid any damage in the pictures, I didn't look that close as the arm was already sold and now the Facebook listing is deleted. I assumed the repair could be seen in the pictures because I do recall the link went to a couple pictures that were much larger. In regards to the length,  I've measured stock arms very recently to order a new stock length and +2 for my bikes. A stock arm is ~18.75" center to center. Best I can tell from pictures yours is a -3 to -3.5". Like I said, maybe you didn't know which is why I suggested he contact you. I don't know either one of you and don't have a dog in the fight.

Hey screamer, ur over thinking this... you need some riding time on your shee, doctors orders lol 😂😂😂 twist that throttle some it will calm u down braaaaapppppp!

[n2otoofast4u]

No dog fight.
Just figuring out what i got
 

Most refer to it as "junk".

Sent from my SM-G930V using Tapatalk

[97Screamer]

3 minutes ago, budnelson15 said:

Hey screamer, ur over thinking this... you need some riding time on your shee, doctors orders lol 😂😂😂 twist that throttle some it will calm u down braaaaapppppp!

I agree doc! Haven't gotten out on my shee in over a year so instead I get bored and read too many forums. Guess I should go start putting pieces on it!

[trickedcarbine]

Don't be silly, SEND IT!

[trickedcarbine]

In all honesty, if there is a sleeve inside the areas it's been joined, it may be ok... Dunno. Looks like a -3 or maybe a touch over. Drill a small 1/16" pilot hole like a 1/2" before the weld and see. It was cheap AF.