banshee throttle sticking

[arena314]

hi so I installed idle screws on my banshee and have t5 pipes and a uni filter with no lid that's it. I'm running 27.5 pilots and 270 mains. I'm having an issue where it'll idle hreat but when I ride it and get on it the idle will go up a lot and the throttle feels like it's sticking almost. this started happening when installing the idle screws. any suggestions? thanks

 

Sent from my SM-G935T using Tapatalk

 

 

[trickedcarbine]

Are you referring to an idle screw kit like what comes with the TORS delete? Where are the air screws set at? It should idle back down when screwing them in. If that doesn't make much difference, you need to check for air leaks. 

 

 

[hoppedupandcutdown]

might have gotten the screws in a little crooked and they are dragging on the side of the ramp. It would only stick until maybe 1/4 throttle, if that much. (until the screws clear the slide)

[arena314]

it's done this to me twice and both times are after the bike got wet I'm starting to think the issue is if a little water gets in the slides it causes the throttle to stick

Sent from my SM-G935T using Tapatalk

[hoppedupandcutdown]

Yes, common knowledge... those carbs hate water.

[arena314]

yeah I've been running no lid I'm going to put the lid back on and try to keep them as dry as possibke

Sent from my SM-G935T using Tapatalk

[hoppedupandcutdown]

I run an EHS Racing lid prefilter on mine, Same jetting as no lid but makes it water repellent.

[arena314]

how much would running a stock lid change my jetting?

Sent from my SM-G935T using Tapatalk