Banshee will not run after some work

[hoppedupandcutdown]

So when I went to put my right slide in, my throttle cable goes slack...

I'm not following?

[Dflynn926]

I'm not following?

I pulled my carbs one at a time. I did the left one and put it back no issues. And the thumb throttle felt normal. When I did the right one and put it back on and then when putting the slide and needle back in, when in fine, but after tightening the top, i felt the throttle and it was like it was already compressed.

[Yamahafan#1]

Pull it back out and make sure it lined up right. And make sure the rubber seal on to of ur carb caps isnt bent or off pull on the throttle cable. And if slide are in the right carbs u should be able to see the dot in the window on the right sides of ur carbs.

[Dflynn926]

Ok I'll try pulling it again. When the slide is out of the carb, the cable feels normal.

[Yamahafan#1]

Ok I'll try pulling it again. When the slide is out of the carb, the cable feels normal.

Then its deff geting hung up on some thing u shouldent realy have to for the carb cap on to screw it on.

[Dflynn926]

Ok so the slide was 180 degrees off... yup I'm dumb Hahaha.

 

Shee runs now... but it just starts to high idle... is this because I cut the tors wires?

[Yamahafan#1]

Ok so the slide was 180 degrees off... yup I'm dumb Hahaha.

 

Shee runs now... but it just starts to high idle... is this because I cut the tors wires?

 

Dose it slowly creep up to a high idle or right off the bat it dose ?

[J-Madd]

Carbs are out of sync.

[Dflynn926]

Dose it slowly creep up to a high idle or right off the bat it dose ?

Right off the bat

[Dflynn926]

Carbs are out of sync.

How do I sync them without the tool

[RIPPIN' IT UP]

Adjust idle & air screws

 

Sent from my ZTE T84 using Tapatalk

[J-Madd]

Take the filter off. And look into the carb.

[RIPPIN' IT UP]

Visually sync the carbs

 

Sent from my ZTE T84 using Tapatalk

[Dflynn926]

How do I visually sync them if i can't run it?

 

So I do need to have idle screws after cutting wires? I was under the impression I could at least start it without putting on the elimination kit on

[J-Madd]

Push the throttle and look at the slides. Make sure they raise and lower at the same time. Adjust the cable on top of one carb to move the slide up or down in the throttle range.